User manual LA CROSSE TECHNOLOGY WS-7034TWC

[. . . ] To complete the set up of your indoor temperature station after the 10 minutes have passed please follow the steps on pages 8-9. INVENTORY OF CONTENTS 1. Instruction Manual and Figure 1 Warranty Card. Holder Figure 2 5 ADDITIONAL EQUIPMENT (not included) 1. 2 Fresh AA Alkaline batteries DETAILED SETUP GUIDE Battery Installation 1. Do not press any buttons for at least ten minutes. Battery Cover 6 Setting the Time 1. [. . . ] These extra remote temperature sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP will monitor the temperature of water or soil via a probe. When setting up multiple remote temperature sensors, it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensors. Second install batteries into the 10 indoor temperature station and do not press any buttons for ten minutes. To view the temperature of a different remote temperature sensor unit, press and release the "SET/CH" button. A shift from one number to the next should be observed in the OUTDOOR LCD. MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a North-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location before permanently mounting. 11 Remote Temperature Sensor 1. Mount the bracket in the desired location with either screws or adhesive tape. Reattach the remote temperature sensor into mounting bracket. 3. Indoor Temperature Station The indoor temperature station comes with the table stand already mounted. If you wish to use the table-stand all that is required is to place the indoor temperature station in an appropriate location. To wall mount the indoor temperature station first remove the table stand. Using the integrated hanging hole on the back of the unit, slip indoor 12 temperature station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed. Remove all batteries, reinsert into remote temperature sensor first, then into the indoor temperature station. Place remote temperature sensor closer to the indoor temperature station. Place remote temperature sensor and indoor temperature station in position 13 so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions, so two sensors could be as much as 2 degrees different. However, the difference can be exaggerated further because the sensors are designed for different working environments. [. . . ] The indoor temperature station will be repaired or replaced with the same or similar model. 17 This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the indoor temperature stations inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS INDOOR TEMPERATURE STATION. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]