User manual LA CROSSE TECHNOLOGY WS-7013TWC

[. . . ] To change between Fahrenheit and Celsius, press and release the MIN/MAX button. When you have your choice shown on the display press and release the SET button once. NOTE: When in the 12h mode there is "PM" displayed under the word TIME when in the PM hours. Press and release the MIN/MAX button until the correct minutes are displayed. [. . . ] Following are some brief instructions for the basic set-up of Remote Control Sender units with the WS-7013U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX2U will monitor temperature only, a TX3U will monitor temperature and 7 display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for use in pools, spas, etc. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the Remote Control Sender units, and in numeric sequence. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. It is necessary to remove the batteries from all units currently in operation. In sequential order, install batteries (follow the same battery installation 8 procedures seen in section I. Follow the Detailed Set-Up Guide for programming and operating instructions. D. To view the temperature of a different Remote Control Sender unit, press the CH button. A shift from one "boxed" number to the next should be observed in the OUTDOOR LCD. To view the Minimum/Maximum temperature: first select from which Remote Control Sender to read data (indicated by the "boxed" number). Pressing the MIN/MAX button will toggle through the minimum and maximum indoor temperature, and the 9 minimum and maximum outdoor temperature. To reset the Minimum/Maximum readings press and the MIN/MAX button for four seconds. V. Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the Sender on an outside North-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location before permanently mounting. B. Remove the mounting bracket from the Remote Control Sender and mount with either screws or adhesive tape. C. The Indoor Temperature Station comes with the table stand already mounted. If you wish to use the tablestand, all that is required is to place the Indoor Temperature Station in an appropriate location. a) Fix a screw (not included) into the desired wall, and place the Temperature Station onto the screw using the hanging hole on the backside. Gently pull the Station down to lock the screw into place. 11 TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: 1) Replace batteries Problem: No outdoor temperature is displayed. [. . . ] To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. [. . . ]