User manual KRESS ABS 156

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. [. . . ] Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. Wear a dust mask and work with a dust/chip extraction unit, if possible to connect. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. During operation, always ensure that the mains and extension cable is to the rear away from the device. Move the switch to the "OFF" position before removing the plug from the plug socket. When the tool is reconnected to the mains accidental starting of the machine is avoided, thus reducing the risk of accidents. Tools not in use must be locked away safely in a dry place out of the reach of children. Do not touch the damaged cable and pull the mains plug when the cable gets damaged during operation. Although this information sheet and the operating manuals for our electrical tools contain extensive instructions on safe working with electrical tools, every electrical tool involves certain residual risks that cannot be completely prevented through safety mechanisms. Therefore, electrical tools must always be operated with the necessary caution. Push the two unlocking buttons 4 and remove the mains cable module 7 from the handle. Continuous electronic control (Option) EN The continuous electronic control keeps the speed almost constant under no-load and under load and ensures uniform performance. Electronic control (Option) In the event of overload or overheating during continuous operation, the speed is automatically reduced until the machine has cooled sufficiently. Soft starter The starting current limitation reduces the starting current. the motor revs up slowly until it reaches the preselected rotational speed. Electronic overload protection With a load that is too high, which therefore implies a risk to the motor, the rotational speed of the milling motor is reduced by the integrated monitoring of the motor. The machine must be released (preferably remove it a short distance from the workpiece) to ensure that you can have full capacity again. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures prevent accidental start of the power tool. The tool insert can become very hot after working for long periods and/or the cutting edges of the tool insert are sharp. clamping the tools The spindle 3 of the milling and grinding motor is equipped with a precision collet chuck 2 to hold the tools. [. . . ] Observe the permissible speed and circumferential speed specified on the label of the grinding tool. The ratings on the type plate of the power tool must not exceed the permissible speed [rpm] and circumferential speed [m/s] of the grinding tools used. For safety reasons, the grinding tools must not be operated at circumferential speeds exceeding 80 m/s. When using grinding tools, always observe the information provided by the grinding tool manufacturer. [. . . ]