User manual KARCHER TB 46

[. . . ] Symbols in the operating instructions ƽ Danger Immediate danger that can cause severe injury or even death. Warning Possible hazardous situation that could lead to severe injury or even death. Caution Possible hazardous situation that could lead to mild injury to persons or damage to property. Safety instructions ƽ Danger of death Violating these safety instructions may result in death through electrocution. [. . . ] The plug and coupling of the extension cable used must be spray watertight. ρ Do not use the mains cable or the cable of the level sensor to transport or fasten the appliance. 14  To separate the machine from the mains, pull the plug and not the power cord. ρ Do not scrape the power cord across sharp edges and ensure that it does not get pressed. ρ The voltage indicated on the type plate must correspond to the voltage of the electrical source. ρ To avoid risks, all repairs and replacement of spare parts may only be carried out by the authorised customer service personnel. ρ Follow the rules for electrical safety of equipment: Immersion pumps should be operated in swimming pools, garden ponds and fountains only using a earth-leakage circuit breaker with a nominal leakage current of max. Do not operate the pump if there are persons located in the swimming pool or the garden pond. For safety reasons, we recommend that you operate the appliance only via a earth-leakage circuit breaker (max. The electrical connection of the system may only be performed by a qualified electrician. In Austria pumps to be used in swimming pools and garden ponds should be equipped with a fixed connection line according to ÖVE B/EN 60555 Part 1 to 3; power supply should be via a ÖVE-tested isolating transformer whereby the secondary nominal voltage should not exceed 230V. Note: Dry run leads to increased wear, switch the pump off within three minutes in case of a dry run. Flat suction (only SCP 12000) In flat suction mode, the fluids can be sucked off up to 1 mm of residual height. σ Fold in the folding feet  Set the IQ Level Sensor to the lowest switching height (very bottom of the guide rail). σ When the height of the remaining fluid is less than 20 mm, press the deaeration key or plug in and disconnect the pump many times till the fluid is sucked in. 16 EN – 4 Finish operation  Disconnect the main plug from the socket. Maintenance and Care ƽ Danger Turn off the appliance and remove the mains plug prior to any care and maintenance work. Especially after running chlorinated water or other liquids that leave residue behind. σ In order to ensure a reliable switching of the pump, the IQ Level Sensor should be cleaned with a cloth (at least every 2 to 3 months). Transport Caution In order to prevent accidents or injuries, keep in mind the weight of the appliance during transport (see Specifications). Storage Caution In order to prevent accidents or injuries, keep in mind the weight of the appliance when selecting a storage location for it (see Specifications). When transporting by hand  Lift appliance by the carrying handle and carry it. [. . . ] Can be used as individual suction assembly combined with connections and suction filters. 0 Stainless steel prefilter The removable stainless steel prefilter increases the functional safety of the immersion pump and protects the pump impeller from clogging. Insert the backflow valve instead of the flat seal to prevent the water from returning into the pump. 4 mm), 10 m EN – 5 17 Troubleshooting ƽ Danger To avoid risks, all repairs and replacement of spare parts may only be carried out by authorized customer service personnel. [. . . ]