User manual KARCHER SC 1402

[. . . ] The unit must be operated with the power supply cord or cable as specified by the manufacturer. Repair and service procedures may only be performed by authorised customer service depots or by experts who are thoroughly familiar with all applicable safety regulations. The power cord and/or extension cord must not be subjected to of mechanical damage by vehicle tyres, or to lateral or longitudinal distress (squeezing, pinching or pulling). The extension cord must have a minimum cable cross section of 1 mm2, and must be spray-water protected. [. . . ] That allow direct steam contact Never fill the tank with solvent-bearing with electrical wiring and switches. This particularly steam could enter into the electrical includes cleaning agents, petrol or paint components and, on condensing, cause an thinner. Use acetone, undiluted acids and solvents, because they attack the materials of which the unit is constructed. Make sure that the water reservoir (B1) is everything is complete (see page 3). Any missing parts or you detect any transport Do not operate the decalcification pump damage, please inform your dealer immediately. Otherwise, you pump water into the appliance which spurts out of the steam Disposal of the packaging. Please do not place the packaging into · plug the mains plug (A7) into a mains plug. The ordinary refuse for disposal, but The steam cleaner is ready for use after arrange for the proper recycling. Push the lock for the steam lever (A4) forwards (steam lever is released). Connect, if necessary, the detail nozzle (C1) or Do not operate the steam lever when the the round brush (C2) with the steam nozzle (A2). Line up both grooves of the accessories with · Turn the accessory clockwise until it locks into The amount of steam flowing out increases place. When using Faults often have simple causes which you can the descaling solution, mind the dosing rectify yourself with the aid of the following suminstructions on the packaging. In case of doubt or of faults or remedies Use caution when filling and emptying the not mentioned here apply to the authorized custeam cleaner. Repair work on the unit can only be carried out · Pour this decalcification solution into the water by the authorized customer service. Steam decreases during the work / no steam Close the water reservoir (B1) with the reservoir cover (B3) and attach the water reservoir at the housing. Turn for this the nozzle insert with ­> refill water a coin in an anti-clockwise direction and pull off Steam lever cannot be pressed anymore the nozzle insert. Steam lever with lock (A4) is locked (lock at the · One minute in regular pump movements until ­> push lock backwards. The decalcification solution escapes from the Safety thermostat open steam nozzle (best over a washbasin) If the temperature control fails and the appliance overheats, then the safety thermostat turns off · Release and empty the water reservoir. Please contact your local Kärcher customer service to arrange for the reset of the · Allow the decalcification solution to take effect safety thermostat. If you always use demineralized or distilled water, a cleaning of the appliance is not required. Only use products approved by Kärcher to exclude any damages of the appliance. Fill the water reservoir (B1) with water and attach the water reservoir at the housing. [. . . ] Regulations can cause optional disorders, for example significantly decreased steam amounts and blockage of the steam nozzle. I soft II medium III hard IV very hard Press the steam lever (A3) and let the appliance evaporate into a washbasin for two minutes. The warranty terms published by our competent sales company are applicable in each country. We will repair potential failures of the appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in fabrication. [. . . ]