User manual KARCHER KM 150 500 R D 4W

[. . . ] Do not use acetone, undiluted Proper Use This high-pressure cleaner is designed for domestic use only: – to clean machines, vehicles, buildings, tools, facades, terraces, garden equipment etc. € with accessories, replacement parts and detergents approved by Kärcher. Please do not place the packaging into the ordinary refuse for disposal, but arrange for the proper recycling. Please dispose your old appliances using appropriate collection systems Warranty The terms of the guarantee applicable in each country have been published by our respective national distributors. [. . . ] Observe a distance of at least 30 cm when using the jet to clean painted surfaces to avoid damaging paintwork. Engine washes, underbody washes, may only be carried out using washing stations equipped with an oil separator. Wear protective clothing and safety goggles to protect against back spray containing water or dirt. Make sure that the power cable or extension cables are not damaged by running over, pinching, dragging or similar. The connection between the power cable and extension cable must not lie in water. All current-conducting parts in the working area must be protected against jet water. The appliance may only be connected to an electrical supply which has been installed in accordance with IEC 60364. The minimum fuse rating required at the socket outlet is 16 A (slow-blow). To avoid accidents due to electrical faults we recommend the use of sockets with a line-side current-limiting circuit breaker (max. This appliance was designed to be used with detergents which are supplied or recommended by the manufacturer. The use of other detergents or chemicals may compromise the safety of the appliance. Detergents To ensure a trouble-free operation of the appliance and to match the individual cleaning task, we recommend our Kärcher detergent and maintenance agents. Push the appropriate spray lance on to the trigger gun and fasten it by turning it through 90°. High pressure operation ṇ Risk of injury The trigger gun is subjected to a recoil force when the water jet is discharged. Make sure that you have a firm footing and are also holding the trigger gun and spray lance firmly. Spray lance with pressure regulation Carrying out the most common cleaning tasks. The work pressure can be stagelessly regulated between "Min" and "Max". English 13 Interrupting operation Release the lever on the trigger gun. During longer breaks (more than 5 minutes), also turn the appliance off using the ON/OFF switch. Maintenance and care ƽ Risk of electric shock Always switch off the appliance and pull out the mains plug before care and maintenance work. In the winter: Pull out the fine filter in water connection using flat-nose pliers and clean with running water. Remove filter from suction hose for detergent and clean with running water. [. . . ] Appliance does not start Check whether the voltage indicated on the type plate corresponds to the voltage of the socket. Pressure does not build up in the appliance Check the setting at the spray lance. Appliance ventilation: Switch on the appliance without connection the HP hose and run it until the water discharging from the HP outlet is free of bubbles. Clean the fine filter in the water supply connection: this can be easily removed using flat-nose pliers. [. . . ]