User manual KARCHER K2200

[. . . ] € with accessories, replacement parts and detergents approved by KÄRCHER. The PS 20 is ideally suited for the highpressure cleaning of stairs and smooth floor surfaces outside (e. Wooden or stone floors, clinker, tiles, concrete) as well as of floor surfaces with a water discharge inside (e. Warranty The warranty terms published by the relevant sales company are applicable in each country. [. . . ] Overflow valve with pressure switch The overflow valve prevents the permissible working pressure from being exceeded. If the lever on the trigger gun is released the pressure switch turns off the pump, the high pressure jet is stopped. Prerequisites for the appliance's stability Caution Create stability for the appliance prior to all work on or with the appliance to prevent accidents or damage. € The stability of the appliance is warranted when it is placed onto an even surface. EN – 7 15 Operation Description of the Appliance These operating instructions describe the maximum equipment. Depending on the model, there are differences in the scopes of delivery (see packaging). 1 Connection for water supply with filter 2 Protective cover 3 Coupling element for water connection 4 Quick coupling for high pressure hose 5 VELCRO® fastener 6 Storage for spray lance 7 Storage for mains connection cable 8 Mains cable with mains plug 9 Appliance switch "0/OFF“/ „I/ON“ 10 Trigger gun 11 Lock trigger gun 12 Clamp for high pressure hose 13 High pressure hose Optional accessories 14 Spray lance with high pressure nozzle 15 Spray lance with Dirtblaster 16 Spray lance with pressure regulation (Vario Power) 17 Washing brush 18 Foam nozzle with detergent container 19 Washing brush 20 Extension tube 21 PS 20 Power Scrubber Special accessories Special accessories expand the possibilities of using your appliance. Illustration  Fasten the quick coupling for the high pressure hose to the high pressure connection. Illustration  Install the protective cap on the water connection and screw on the coupling. Water supply According to the applicable regulations, the appliance must never be used on the drinking water supply without a system separator. Caution Always connect the system separator to the water supply, never directly to the appliance!Note: Impurities in the water can damage the high-pressure pump and accessories. For protection, the use of the KÄRCHER water filter (optional accessory, order no. σ Push the water supply hose onto the coupling unit, then connect it to the water supply. Before Startup Mount loose parts delivered with appliance prior to start-up. Illustration  Pull out the clamp for the high-pressure hose from the trigger gun (e. 16 EN – 8 Start up Caution Dry runs lasting longer than two minutes lead to damages to the high pressure pump. If the appliance does not build up pressure within two minutes, switch it off and proceed as instructed in the Chapter "Troubleshooting". σ Push the high pressure hose into the quick coupling until it locks audibly. σ Push the spray lance into the trigger gun and fasten it by turning it through 90°. Operation ṇ Danger The trigger gun is subjected to a recoil force when the water jet is discharged. Make sure that you have a firm footing and are also holding the trigger gun and spray lance firmly. [. . . ] 671-xxx Relevant EU Directives 2006/42/EC (+2009/127/EC) 2004/108/EC 2000/14/EC 2011/65/EC Applied harmonized standards EN 50581 EN 55014–1: 2006+A1: 2009+A2: 2011 EN 55014–2: 1997+A1: 2001+A2: 2008 EN 60335–1 EN 60335–2–79 EN 61000–3–2: 2006+A1: 2009+A2: 2009 EN 61000–3–3: 2008 EN 62233: 2008 Applied conformity evaluation method 2000/14/EC: Appendix V Sound power level dB(A) Measured: 84 Guaranteed: 87 The undersigned act on behalf and under the power of attorney of the company management. Feed volume 8 I/min Feed pressure 0, 2-1, 2 MPa Performance data Working pressure 8 MPa Max. Permissible pressure 10 MPa Water flow rate 5, 5 I/min Detergent flow rate 0, 4 I/min Recoil force of trigger gun 10 N Dimensions and weights Length 436 mm Width 173 mm Height 247 mm Weight, ready to operate with 4, 5 kg accessories Values determined as per EN 60335-2-79 Hand-arm vibration value <2, 5 m/s2 Uncertainty K 0, 3 m/s2 Sound pressure level LpA 72 dB(A) 3 dB(A) Uncertainty KpA Sound power level LWA + Un87 dB(A) certainty KWA Subject to technical modifications!Børn skal være under opsyn for at sørge for, at de ikke leger med maskinen. [. . . ]