User manual KARCHER CV 85 2 RS

[. . . ] Htm Contents Safety instructions Function Proper use Environmental Protection, Disposal EN EN EN EN 1 1 1 1 2 3 4 5 5 5 7 7 8 8 8 8 Operating and Functional El- EN ements Before Commissioning Operation Transport Storage Maintenance and care Faults Accessories Specifications Spare parts Warranty CE declaration EN EN EN EN EN EN EN EN EN EN EN - Proper use Use this appliance only as directed in these operating instructions. € The appliance may only be equipped with original accessories and spare parts. – The application temperature ranges from +5°C to +40°C. € The machine should not be used on surfaces that are sensitive to pressure. [. . . ] Apply the immobilising brake again immediately after finishing pushing the machine by pushing the unlocking lever upward. Get on to the standing area and keep the safety pedal depressed with the left foot. To drive, press the accelerator pedal carefully and drive down slowly from the palette. Operation Note Take the foot off the aceelerator pedal, press the emergency-stop button to immediately deactivate all functions and turn the key switch to the "0" position. Carry out maintenance jobs "daily before starting work" (see section "Maintenance and Care"). Unloading Note Take the foot off the aceelerator pedal, press the emergency-stop button to immediately deactivate all functions and turn the key switch to the "0" position. Place the enclosed wooden board at the back of the appliance on the pallet as a ramp and attach with screws. The immobilizing brake must always be checked first on an even surface before starting the machine. If the appliance can be moved by hand, the parking brake is not engaged. If the appliance can still be moved by hand, the parking break is defective. If the appliance cannot brake adequately while going downhill, press the emergency stop button. Driving Carry out the initial trials in an open surface so that you familiarise yourself with the appliance. The gradient perpendicular to the direction of travel should not exceed 10%. Get on to the standing area and keep the safety pedal depressed with the left foot. You can thus clean very dirty surfaces by driving back and forth a couple of times. Overload In case of overloading, the drive motor automatically switches off after a certain period. Vacuuming completed Move upward the lever for raising / lowering brushing/ vacuuming unit - sidebrush and brushing/ vacuuming head will be raised and switched off. Before carrying out any tasks on the machine, set the main key to "0" and remove it. Carry out maintenance jobs "daily/ after finishing work" (see section "Maintenance and Care"). Secure the machine with wheel chock(s) to prevent it from rolling away. maintenance schedule Daily Before starting working: Check tyre status. Check safety pedal, accelerator pedal and steering wheel for correct functioning. [. . . ] We will repair potential failures of your appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in manufacturing. In the event of a warranty claim please contact your dealer or the nearest authorized Customer Service centre. Relevant EU Directives 2006/42/EC (+2009/127/EC) 2004/108/EC Applied harmonized standards EN 55014–1: 2006 EN 55014–2: 1997 + A1: 2001 EN 60335–1 EN 60335–2–29 EN 60335–2–72 EN 61000–3–2: 2006 + A2: 2009 EN 61000–3–3: 2008 EN 62233: 2008 Applied national standards The undersigned act on behalf and under the power of attorney of the company management. Yderligere ved servicefrie batterier (vådbatterier): Tilsæt destilleret vand en time før slutningen af opladningen, sørg for korrekt syrestand. [. . . ]