User manual JUNO JKI3063

[. . . ] " It is dangerous to alter the specifications or modify this appliance in any way. " Care must be taken to ensure that the appliance does not stand on the electrical supply cable. " The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. " Manufacturers' storage recommendations should be strictly adhered to. [. . . ] Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. " Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. " The appliance must not be located close to radiators or gas cookers. " There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. " For freezers only (except built-in models): an ideal location is the cellar or basement. 9 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Instructions for totally built-in appliances Dimensions of the recess Model Height Depth Width JKI 3033 880 mm 550 mm 560 mm JKI 3053 1030 mm 550 mm 560 mm JKI 3063 1225 mm 550 mm 560 mm Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). For building into kitchen units follow the special "Building-in" instructions given. The appliance's door have been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. 50 mm min. 1 2 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. D022 min. cm 200 2 For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. D567 Fig. 2 A Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. D265 If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 10 Fig. 8 Open the door and push the appliance against the side of kitchen furniture opposite to that of apD pliance hinges. [. . . ] In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. D351 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Fig. 10 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment trough to prevent the water overflowing and dripping onto the food inside. [. . . ]