User manual JUNO JKG6493

[. . . ] " It is dangerous to alter the specifications or modify this appliance in any way. " Care must be taken to ensure that the appliance does not stand on the electrical supply cable. " The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. " Manufacturers' storage recommendations should be strictly adhered to. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. 2: Attention: keep ventilation openings clear of obstruction. 50 mm min. cm 200 2 C Press in the joint covers between the appliance and the kitchen furniture. D369 Fig. 6 D526 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D098 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 D023 If after having carried out the operation described in section 3 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 B A D096 D265 17 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 In case of side fixing of the appliance, it will be sufficient to loose the screws fixing the bracket (G) and to position it as shown in Fig. 11 H G 20m m D397 G D094 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. Pilot light Use of the freezer Operation Insert the plug into the wall socket. The pilot light will light up, indicating that the appliance is powered. Turn the thermostat knob, clockwise, beyond the «O» (STOP) position. To stop the appliance, turn the thermostat knob to position «O». Fast freezing To start fast-freezing food, turn the knob towards «S». Pilot light (D) will come on. Warning light Warning light (C) lights up when the temperature inside the freezer compartment has increased to a value which jeopardizes the long-term storage of food in the compartment. When the appliance is switched on for the first time or when food is placed in the compartment for freezing, it is normal for this light to remain on until the temperature has reached the level required for correct storage. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. In addition, never put hot foods or liquids in the freezer compartment and take care not to fill recipients up to the brim if they are covered with a lid. [. . . ] Introduce the plastic scraper in the appropriate seating as shown in Figure 16, place underneath a basin to collect the defrost water. 16 D068 Keep the scraper for future use. 22 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Replacing the interior light bulb The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. [. . . ]