User manual JUNO JGI4421

[. . . ] It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. The appliance's door have been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. To obtain the best performance from this appliance, you should: · Make sure that the commercially frozen foodstuffs were adequately stored by the retailer; · Be sure that frozen foodstuffs are transferred from the foodstore to the freezer in the shortest Possible time; not open the door frequently or leave it open longer than absolutely necessary. [. . . ] When defrosting is completed, dry the interior thoroughly and refit the plug; keep the scraper for future use; 5. Turn the thermostat knob back to the required setting or replace the plug in the power socket. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. Important: Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a maechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. The 4-star compartment is suitable for long term storage of commercially frozen food and for freezing fresh food. To freeze fresh foods allow it to run on the fast freeze setting for at least 24 hours before loading food. Important If there is a power failure when food is in the freezer, do not open the door of the freezer compartment. The frozen food will not be affected if the power cut is of short duration (up to 6-8 hours) and the freezer compartment is full, otherwise, it is recommended that the food should be used within a short time (a temperature increase of the frozen food shortens its safe storage period). Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. 13 Use - Freezing fresh food - Storage of frozen food - - Thawing - Ice-cube production - Cold accumulator . It is most important that this instruction book should be retained with the appliance for future reference. [. . . ] Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Care should be taken when moving it Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. [. . . ]