User manual HARMAN KARDON MS 100

[. . . ] banner head MS 100 MUSIC SYSTEM OWNER'S MANUAL 1 SaFeTY InFOrMaTIOn Important Safety InStructIonS 1. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] To arm the alarm, use the / Buttons to change the Alarm message to "Alarm On", and press the Alarm Adjust Mode Button again when you are finished. The Timer indicator will appear in the Message Display when the alarm has been set. At the set time, the MS 100 will automatically turn on and begin playing the selected source. If CD or iPod was selected and there is no disc loaded or iPod docked, the MS 100 will switch to the FM radio source. Play will begin at volume level 8, and steadily increase to a volume level of 20 within 3 minutes. It will continue to play at level 20 for 45 minutes, and then shut off automatically. Press and hold the Standby Button while the alarm is playing to turn it off and return to normal play. using the remote control Point the remote at the front of the MS 100. The remote IR sensor is located in the middle of the front panel, behind the mesh grille, about 25mm above the CD slot. The remote has a range of approximately 6m, up to 30 degrees off center. If the batteries require replacement, see Step 2 of the Installation section. Use caution and dispose of batteries according to environmental requirements. Never throw the batteries into fire, and remove them from the remote if it will be unused for a long period of time. Volume control Use the front-panel or remote Volume Controls to raise or lower the volume. Use caution with volume levels to avoid damage to your hearing or equipment. The volume level appears in the Message Display when the Volume Controls are used. To temporarily silence playback, press the Mute Button on the remote, or simultaneously press the front-panel Volume Up and Down Buttons. Press the Mute Button or either Volume Control to resume normal volume. Source playback will continue during muting. 30º STANDBY ON 30º SOURCE TUNE PLAYBACK SLEEP CLOCK ADJ ALARM ADJ PR­ EJECT PR+ TUNE­ TUNE+ MUTE Setting the clock VOLUME Before turning the unit on, set the clock: Press the Clock Adjust Mode Button on the remote, and use the / buttons to set the correct hour and minute settings when they flash. Use the / Buttons to move the cursor to the previous or next position, and press the Clock Adjust Mode Button again when you are finished. See Figure 1. Source Selection The first time the MS 100 is turned on, it will default to FM Radio. Each press of the Source Selector switches to the next source in this order: FM, CD, AUX LINE IN 1 (rear-panel 3. 5mm analog input), AUX LINE IN 2 (front panel), AUX LINE IN 3 (rearpanel dual RCA jacks), AUX DIGITAL IN, iPod. Subsequently, the MS 100 will select the last source used before turn-off. turning on the mS 100 To turn on the MS 100, press the Power On Button on the remote, or press the On/Standby Button on the main unit. The FM Radio will begin to play. fm radio Press the Tuning Mode Button to select Automatic or Manual tuning. [. . . ] Each press of the Playback Mode Button switches the mode as follows: Repeat 1 Track, Repeat All Tracks (in the current playlist), Shuffle Albums, Shuffle Albums with Repeat All, Shuffle Tracks, Shuffle Tracks with Repeat All, and Normal Play. To navigate the menus on the iPod: · Press the Button to display the menu or return to the previous menu level. · Press the · Press the / Button to select the current item. Buttons to scroll up or down. During play, the current track and total number of tracks in the current playlist will display alternately with the elapsed and total times. [. . . ]