User manual HARMAN KARDON HD 755

[. . . ] HD 755 CD Player OWNER'S MANUAL HD 755 Power for the Digital Revolution® Table of Contents 2 3 4 4 5 6 7 9 10 10 10 11 11 11 11 12 12 12 13 13 13 13 14 15 16 Typographic Conventions Introduction Information Unpacking Front Panel Controls Rear Panel Connections Remote Control Functions Installation Operation Loading and Unloading Discs Normal Play HDCD® Discs Play Headphone Listening Display Dim Time Display Search Skip Intro Search Programmed Play Operation Programmed Play Checking Program Contents Clearing Programs Repeat Play Troubleshooting Guide Technical Specifications Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Château-du-Loir, FRANCE declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 60065:1993 EN 55013/A12/8. 1994 EN 55022/5. 1995 EN 55020/12. 1994 EN 61000-3-2/4. 1995 EN 61000-3-3/1. 1995 Carsten Olesen Harman Kardon Europe 01/04 Typographic Conventions In order to help you use this manual with the remote control, front panel controls and rear panel connections, certain conventions have been used. EXAMPLE ­ (bold type) indicates a specific remote control or front panel button, or rear panel connection jack. EXAMPLE ­ (bold type) indicates a message in the front panel information display. 1 ­ (number in a square) indicates a specific front panel control. [. . . ] Connect the sensor to the Remote IR-In Jack £ on the rear panel. This jack may also be connected to the IR-Output jack of another compatible Harman Kardon component or a compatible IRsystem- remote product. You may also use the IR Sensor in the HD 755 to send commands to other compatible remote controlled products. Connect the Remote IROut jack ¢ to the input of the other product or system. © Connect the power to a nonswitched AC wall outlet or to the accessory outlet on the rear of another audio device in your system and you are ready to go!NOTE: When using the accessory outlet on another product to power the HD 755 make certain that it has the compatibility to power a device that draws at least 14 watts of current in addition to being able to handle the requirements of the other devices that may be plugged into the accessory outlets. If you use a "switched" outlet, it is important to remember that the host product must be turned on in order for the HD 755 to operate. INSTALLATION 9 Operation Loading and Unloading Discs To load a disc, first turn the unit on (if not so already) by pressing the Power Switch 1 on the front panel or the Power On button 1 on the remote, then press the Open/Close button $ F taking care to make certain that the space in front of the drawer is not obstructed. Note that if the drawer is blocked when attempting to open it, it will automatically stop the motor for opening the tray after 10 seconds and an ERROR message will appear in the front display to protect the mechanism. When the unit is turned off (to Standby), pressing any button on the front panel will turn the unit on. When Play button 4 9 on the front or on the remote is pressed, the unit will automatically turn on and start playing the disc actually loaded. When an 8cm disc is played, it should be carefully centered within the smaller ridges inside the cassette drawer. Disc Handling Notes When loading or unloading discs, it is best to hold them by the edges. While Compact Discs are very reliable, rough handling may damage them. Avoid scratching the bottom (non-printed) side of discs, or any handling which will leave fingerprints. To avoid damage to the disc and player, always seat discs so that they are centered in the tray. Do not lift the player while the disc tray is opening or closing, as this may cause the disc to unseat from the tray and possibly jam. Pressing the Open/Close button once a disc has been carefully seated will close the disc drawer while the message CLOSING will appear in the information display. As soon as the tray is closed the display will show the message TRACKING while the table of content (TOC) of the disc is read. Note that particulary with CD-RW discs this tracking may take some time due to the reflectibility and data structure different from normal discs. Afterwards the Information Display will show the total number of tracks on a disc and the total running time of the disc. TRACK MIN SEC Normal Play To play a disc, first turn the HD 755 on using the Power Switch 1 on the front panel or the Power On button 1 on the remote control. When the unit is turned off (to Standby), pressing any button on the front panel will turn the unit on. When Play button 4 9 on the front or on the remote is pressed, the unit will automatically turn on and start playing the disc actually loaded. To load or change a disc open the disc drawer by pressing the Open/Close button $ F. [. . . ] Repeat One Track To repeat the track in play, press the Repeat button !5 once. When the unit is in Stop mode, press Repeat once, select the track to be repeated with the Skip or Numeric buttons as described on page 10, and press Play 4 9. The REPEAT and 1 indicators will light and the track will continue to play over and over again continuously. If the track is changed by pressing the Skip buttons 7 7 while the Repeat function is in use, the newly selected track will be repeated. [. . . ]