User manual HARMAN KARDON AVR 154

[. . . ] AVR 154 AUDIO/VIDEO RECEIVER OWNER'S MANUAL SAFETY INFORMATION Important Safety Instructions 1. The A/V receiver's cabinet may be cleaned by gently wiping with a soft cotton or microfiber cloth. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] Use the < / > Buttons to select either SMALL or LARGE for these speakers. CENTER: Move the cursor to the line for the center speaker, and use the < / > Buttons to select a setting for this speaker. NOTE: If the receiver is currently in one of the Logic 7 surround modes, which will be the case the first time you turn it on, you won't be able to set the center speaker to LARGE, due to the requirements of the Logic 7 processor. Later on, if you find the SMALL setting is not satisfactory, change the surround mode to one of the Dolby Pro Logic II modes (using the Surround Select menu, accessible from the Master Menu), and then return to this menu to change the center speaker to the LARGE setting. SURROUND: Move the cursor to the line for the surround, or rear, speakers, and use the < / > Buttons to select a setting for these two speakers. SUBWOOFER: Move the cursor to the line for the subwoofer, which is programmed a little differently. The subwoofer's "size" setting depends upon how you programmed the front left and right speakers. · If you set the front speakers to SMALL, the subwoofer setting will be SUB, and you won't be able to change it. If you don't have a subwoofer, you may wish to set your front speakers to LARGE so as not to lose this information, but you may need to lower the volume to avoid adverse results. Either upgrade to full-range speakers or add a subwoofer to your system at the earliest opportunity. · If you set the front speakers to LARGE, you may select from three possible settings for the subwoofer: Figure 44 ­ Speaker/Channel Input Indicators BASS MGR: This advanced setting is used to configure your speakers differently for different sources, e. g. , to set the speakers to LARGE while listening to your CD player. By changing this setting to INDEPENDENT, you may have different settings for your CD player and your DVD player or other devices. We recommend that you leave this setting at its factory default of GLOBAL until you have more experience with the AVR. Move the cursor to the BACK TO MANUAL SETUP line and press the OK Button to return to the Manual Setup Menu. The speaker sizes may also be configured without using the on-screen menu system. Press the Speaker Setup Button on the remote, and use the //¤ Buttons to select the desired speaker group (Front Speakers, Center Speaker, Surround Speakers, Subwoofer). Press the OK Button to display the current setting for the speaker group, and use the //¤ Buttons again to change the setting. Press the OK Button to return to the previous display, or wait a few seconds for the AVR to return to normal operation on its own. NOTE: The Speaker/Channel Indicators on the front panel of the receiver (see Figure 44) display the speaker size settings as follows. For each speaker configured as SMALL, a single box appears in its position. For each speaker configured as LARGE, a double box appears in its position. The subwoofer is indicated by a single box, or no box if no subwoofer has been configured. [. . . ] Input Select Volume Up Channel ­ OSD TV/Video Volume Down Guide Menu Up Left Set/Enter Right Down Prev Channel 1 2 3 4 5 6 7 8 9 0 51 Mute AVR Select DVD Select VCR Select HDMI 1 Select Tuner Select CD Select HDMI 2 Select AUX Select Tape Select TV Select HDMI 3 Select Mute AVR Select DVD Select VCR Select HDMI 1 Select Tuner Select CD Select HDMI 2 Select AUX Select Tape Select TV Select HDMI 3 Select Channel + HDMI 1 Select HDMI 1 Select HDMI 1 Select HDMI 1 Select 10 VID 2 (CBL/SAT) Video 2 Select CBL/SAT Select CBL/SAT Select CBL/SAT Select CBL/SAT Select CBL/SAT Select CBL Select AUX Select Tape Select TV Select Channel + 6 Ch. Input Select Volume Up Channel ­ Live TV TV Input Volume Down Guide Menu Up Left Enter Right Down Open/Close 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 Menu Up Left Select Right Down Return/Exit Disc Menu Setup Up Left Enter Right Down Open/Close Status 1 2 3 4 5 6 7 8 Zoom 9 0 9 0 AUX Select Tape Select TV Select Audio Find 6 Ch. Input Select Volume Up Channel ­ OSD TV/CBL Info/Guide Menu Up Left Enter Right Down AUX Select Tape Select TV Select Channel + CBL/SAT Select CBL/SAT Select HDMI 2 Select HDMI 2 Select HDMI 2 Select HDMI 2 Select HDMI 3 Select HDMI 3 Select HDMI 3 Select HDMI 3 Select DSP Surround Mode Disc Menu or Title Select OSD TV/DVD or V. OFF Volume Down Channel Trim Move/Adjust Up Move/Adjust Left OK Move/Adjust Right Move/Adjust Down Digital Input Select 1 2 3 4 5 6 7 8 Tuner Mode 9 0 Volume Down Title or Disc Menu Menu or Setup Up Left Enter Right Down Open/Close Return or Status 1 2 3 4 5 6 7 8 9 0 Input Select Volume Down Continuous Play Intro Scan Volume Down Volume Down Volume Down Menu Up Left Enter Right Down Prev Channel 1 2 3 4 5 6 7 8 9 0 25 Speaker/Menu Speaker Adjust 27 fi 28 OK 29 fl 30 ¤ 31 Digital/Exit 33 1 34 2 35 3 36 4 37 5 38 6 39 7 40 8 41 Tun-M 42 9 43 0 51 32 Delay/Prev. [. . . ]