User manual HAIER HLP21N

[. . . ] This includes the foam and any adhesive tape both inside and outside of the unit. Inspect and remove any remains of packing, tape or printed materials before powering on the Washer. Before throwing away your old appliance, remove the door so that children may not easily become trapped inside. This easy-to-use manual will guide you in getting the best use of your washer. [. . . ] An "off-balance" washer will not function properly and can stop. The leveling leg can be adjusted by turning the center foot counter-clockwise to raise the foot and clockwise to lower the washer. Once the foot is at the right height, then lock that positi on us i ng the outer and larger ri ng of the fi xed foot. Note: If the washer is inclined more than 2°, the machine will not operate. This washer can convert from fixed feet to casters for mobility and portability. The best time to change from fixed feet to casters is when installing the bottom panel. Screw each of the 4 casters to the bottom base by hand first, then use a wrench to secure the caster's locking bolt to the washer body. Read the installation instructions carefully and ensure washer location before beginning. When installing the quick sink faucet adapter to the faucet, follow the steps below: 1. First, remove the aerator from your faucet nozzle and determine the size/type of the faucet. Once you determine the size/type of the faucet (Outside Threaded End or Inside Threaded End), place the proper sized rubber washer into the silver faucet adapter. Attach the other end of the water inlet hose to the washer water inlet and make sure that the rubber washer is placed in between. As a second option, you can install directly to a fixed utility hot and cold water outlet by using a "Y Hose" (NOT supplied) . The drain hose must be placed into a drainpipe or sink at least 1-1/2 inches in diameter. To avoid possible water back-up, the drain hose must reach a height of at least 31-1/2 inches minimum and 40 inches maximum. Laundry tub: Just hang hook over side of sink or for a more permanent use plastic ties. Plug fin the washer to a regular 120 Volt / 60 Hz, 15 Amps outlet, only after all water and drain lines are connected . Note: Carefully inspect for any leaks around the machine and at the back. If after completing these steps you are still unsure whether unit has been properly installed, contact a qualified installer. start/Pause: (2) · Press this button once to start the wash process. Press this button once again to pause the activity during the wash cycle. There are 3 main washing cycles, Normal, Heavy and Quickwash, along with a total of 7 wash operation options. [. . . ] The spinning is intermittent when it starts ­ The laundry needs to be balanced to avoid slanting. During the final spinning, it stops, the "Rinse" indicator lights up and the washer starts to fill with water ­ The wash load is slanting on one side. Full ONE Year Warranty For 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. Limited Warranty After one year from the original retail purchase date, Haier will provide a part at no cost, as indicated below, to replace said part as a result of a defect in materials or workmanship. [. . . ]