User manual HAIER DW9 TFE3ME-F

[. . . ] Getting to know your dishwasher How to fill the salt How to fill rinse aid How to fill the detergent dispenser Not suitable for the dishwasher How to keep your dishwasher in shape If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out. The mains electricity supply must conform to the details shown on the dishwasher nameplate. [. . . ] If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. How to use the lower rack We recommend that you place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. The values can vary considerably according to: Close the door after loading the appliance. After 3 seconds the appliance emits a short warning signal, and start the programme , the state indicator "A" blinks . Six beeps will indicate that the wash cycle has finished and the state indicators "A" light. switching the dishwasher OFF Several minutes after the programme has ended: Set On-Off button to Off Open the door . notice: When the appliance is already underway press the button "B" for 3 seconds, all of the settings will be cancelled. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. delayed start programming You can delay the start of a programme in increments of 1 hour up to 24 hours. Immediately press the Delayed Start button " F ", the delayed start indicator " E " blinks, the remaining time indicator " G " changes to " ". Press the Delayed Start button for 2 seconds until the numerical display show the required delay. To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator " E" goes out. After 3 seconds the delayed start indicator " E " blinks, the time-remaining indicator " G " will blink and decrease , the programme will start until the delayed start indicator " G " goes out . A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the Detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, " Loading the To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled "Reset drain function", and select the programme you wish (see the paragraph entitled, "Switching When using "3 in 1"combination products, the rinse-aid and salt lights are no longer useful. It may be helpful to select the lowest possible setting for water hardness. If you decide to switch to the use of a standard detergent system we advise that you: 1: Refill both the salt and rinse aid compartments. 2: Switch the water hardness setting to the highest possible position and run for three normal cycles without a load. 3: Readjust the water hardness setting again according to the conditions for your region (For more information please refer to your instruction manual). [. . . ] Plastic items are discoloured Not enough detergent was added to dispenser. White stains are left on crockery, glasses have a milky appearance Not enough detergent was added to dispenser compartment. If you used a phosphate-free detergent , try a detergent containing phosphates and compare results. Have not been dried Selected programme did not include drying function. [. . . ]