User manual GLEM GV75TXBK

[. . . ] The manufacturer will not be liable for injury to persons or animals or property damage caused by an incorrect installation. If the installation requires modifications to the home's electrical system or if the socket is incompatible with the appliance's plug, have changes or replacements performed by professionally-qualified person. In particular, this person must also make sure that the section of the wires of the socket is suitable for the power absorbed by the appliance. Use of a gas cooking appliance produces heat and moisture in the room in which it is installed. [. . . ] Note: continuous use could cause the burners to change colour due to the high temperature. The hot plate has a special seal which prevents liquid from infiltrating into the cabinet. Strictly comply with the following instructions in order to correctly apply this seal: - take off all the movable parts of the hob. - Cut the seal in 4 parts of the necessary lenght to Positionning it on the 4 edges of the crystal. 11/A) under the edge of the hot plate itself, so that the outer side of the seal perfectly matches the outer perimetral edge of the crystal. - Evenly and securely fix the seal to the crystal, pressing it in place with the fingers. - Insert the cooking hob in the hole of the kitchen cabinet by exercising a certain level of force in order to get over the resistance of the hooks (fig. - In order to avoid accidental touch with the overheating bottom of the hob, during the working, is necessary to put a wooden insert, fixed by screws, at a minimum distance of 70 mm from the top (see fig. The hot plate has a special seal which prevents liquid from infiltrating into the cabinet. Strictly comply with the following instructions in order to correctly apply this seal: - take off all the movable parts of the hob. - Cut the seal in 4 parts of the necessary lenght to Positionning it on the 4 edges of the crystal. 11/A under the edge of the hot plate itself, so that the outer side of the seal perfectly matches the outer perimetral edge of the crystal. - Evenly and securely fix the seal to the crystal, pressing it in place with the fingers. - Position the hob in the hole in the unit and fasten it in place using the appropriate screws "F" of the fastening hooks "G" (see fig. - In order to avoid accidental touch with the overheating bottom of the hob, during the working, is necessary to put a wooden insert, fixed by screws, at a minimum distance of 70 mm from the top (see fig. The bottom of the hob must rest on Caution: Do not allow the glass (A) lay directly on the work top. It is the metal bottom "carter" (B) that has to be in touch with the work top (see fig. T INSTRUCTIONS he installer should note that the appliance that side walls should be no higher than the hot plate itself. Furthermore, the rear wall, the surfaces surrounding and adjacent to the appliance must be able to withstand an temperature of 90 C. The adhesive used to stick the plastic laminate to the cabinet must be able to withstand a temperature of not less than 150 C otherwise the laminate could come unstuck. The appliance must be installed in compliance with BS 6172 1990, BS 5440 part. This appliance is not connected to a device able to dispose of the combustion fumes. [. . . ] Before leaving the factory, this appliance will have been tested and regulated by expert and Specialized personnel in order to guarantee the best performances. Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention. For this reason, always contact your Dealer or our nearest After Sales Service Center whenever repairs or adjustments are required, specifying the type of fault and the model of the appliance in your possession. Please also note that genuine spare parts are only available from our After Sales Service Centers and authorized retail outlets. [. . . ]