User manual GEMINI MM-02

[. . . ] ATTACHMENTS: Do not use attachments not recommended by the product manu facturer as they may cause hazards. WATER AND MOISTURE: Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like. ACCESSORIES: Do not place this product on an unstable cart, stand, tripod, brack et, or table. The product may fall, causing serious injury to a child or adult, and seri ous damage to the product. [. . . ] DAMAGE REQUIRING SERVICE: Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: · If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal oper ation. When the product exhibits a distinct change in performance, this indicates a need for service. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. SAFETY CHECK: Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. WALL OR CEILING MOUNTING: The product should not be mounted to a wall or ceil ing. HEAT: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. POWER-CORD PROTECTION: Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. OUTDOOR ANTENNA GROUNDING: If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as This state of the art mixer is backed by a three year warranty, excluding crossfader and channel slides. The crossfader and channel slides are backed by a separate 90 day warranty. - 4U 19" Rack Mounted Club Mixer - 4 Stereo Channels - 7 Line, 2 Mic, 2 Convertible Phono/Line, RCA Inputs - 3 band Rotary Master EQ Control with Cut Feature - Master, Zone and Record RCA Outputs - Fully Removable, User Replaceable Rail Glide Cross Fader - Push Button Mono Control - Rotary Gain Control Per Channel - XLR Mic Input with 2 band Rotary Control EQ Volume - Dual Display with Bright LED - Auto Talk-Over Feature - Push-Button Cueing with Cue/PGM Fader Control - Balanced Master Output - Top Located 1/4" Headphone Input - The ZONE (5) output jacks allow the connection of an additional amplifier with RCA cables. - The REC (4) output jacks can be used to connect the mixer to the record input of your recording unit, thus enabling you to record your mix with RCA cables. Located on the rear panel are 2 Phono(PH)/Line(LN) convertible RCA inputs (11, 14), and 5 line RCA inputs (7, 8, 10, 15, 17). The convertible RCA inputs (11, 14) for Channel (CH) 2 (40) & 3 (44) allow PH and LN level equipment to be connected to the mixer. When using (a) turntable(s), you will need to ground the RCA cable(s) by screwing in the grounding fork(s) to the GROUNDING SCREW (12) located in the back panel of the MM-02 mixer. The stereo LN INPUTS only accept line level inputs such as a CD, DAT, MiniDisc, etc. All operating instructions should be read before using this equipment. In the USA ~ if you experience problems with this unit call Gemini Customer Service at: 1 (732) 738-9003. Do not expose this unit to direct sunlight or to a heat source such as a radiator or stove. When moving this equipment, it should be placed in its original carton and packaging. Headphones may be plugged into the face-plate located 1/4" HEADPHONE JACK (18). [. . . ] MIC SECTION: Plug your main mic into the MIC 1 XLR input (28) located on the top panel. the rotary controls for HIGH (30) and LOW (31) for MIC 1 (28) allow you to adjust the tone of MIC 1. The MIC 1 rotary volume control (29) , above the HIGH(30)/LOW(31) controls, adjust the decibel level of MIC 1 (28). You may also plug a second mic into the rear panel's MIC 2, ¼" jack (16). [. . . ]