User manual FLYMO LAWNRAKE

[. . . ] The operator or user is responsible for accidents or hazards occurring to other people or their property. Installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Before use, examine cable for damage, replace it if there are signs of damage or ageing. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. [. . . ] On slopes, be extra careful of your footing and wear non-slip footwear. Never operate the product with damaged guards or without guards in place. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Do not tilt the product when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operating position before returning the appliance to the ground. Never pick up or carry the product when it is operating or still connected to the mains supply. Remove the plug from the mains : - before leaving the product unattended for any period; - before clearing a blockage; - before checking, cleaning or working on the appliance; - if you hit an object. Do not use until you are sure that the entire product is in a safe operating condition. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving and fixed parts of the machine. Do not force the lawnrake through long grass it should be used on grass no longer than 75mm in length. Clear the lawn of any loose debris or stones that · may damage the lawnrake. On your first use choose a medium height to start with, and then adjust the height setting to suit your lawn and use. To maintain the quality of your lawnrake it is recommended that you clean it after use. Remove the screw from the central disc on the set of tines you wish to replace (L) 4. Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products' life. Awareness of the environment must be considered when disposing of `end-of-life' product. If necessary, contact your local authority for disposal information. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Tines, Electric Mains cable. Husqvarna Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna Outdoor Products, or by the machine having been modified in any way. Maintenez toujours le câble à distance de l'appareil et opérez toujours à distance du point d'alimentation en effectuant des déplacements aller-retour, jamais circulaires. [. . . ]