User manual FAGOR VFI400R

[. . . ] Activate the element on which you have placed the receptacle by pressing the corresponding key (2. : If you take longer than 5 seconds to select the element, the hob will automatically turn itself off, as a safety measure. If the type of connection is other than 220240V~, remove the cable and make the connection as per diagrams (1. Once you , have selected the power, press and this will activate the double element (2. [. . . ] Once the time has passed, the alarm will sound until you press any key. You have 5 seconds to select the desired level, you are advised to use levels from 3 to 6 (2. After five seconds the rapid heating will be set and will appear on the display screen of the selected element (2. You have 5 seconds to select the desired level, you are advised to use levels from 3 to 6 (2. After five seconds the rapid heating will be set and and the power will be displayed alternately. Once the maximum temperature has been will disappear, leaving the reached, power constant. Models dfghjklmo: Select an element and set it at the maximum power by pressing until a 9 and a dot are displayed (2. After 5 seconds, fast heating is set and the power will be displayed followed by a dot (2. To cancel the function, press the key of the programmed element and select a new power. Make sure that the element you are going to activate is the element you want to use (2. Turn the control to the desired position and the `on' light will come on (2. 2) which also indicates the residual heat when the element is turned off. On the models with double elements or a large hotplate, turning the control to the left will adjust a part of the element and turning the control to the right will adjust the whole element (2. They can stain the glass, unless they have a stainless steel protective base. Make sure that the diameters of the receptacles are larger than or the same as the element to be used and place them in the centre of the heat source. They operate with longer or shorter on and off periods depending on the desired power. Once a week, clean thoroughly with products specifically designed for vetroceramic hobs. If you accidentally burn some sugar, sugary elements or plastic on the hob, remove it as soon as possible with a scraper while it is still hot. After using the hob, the elements will stay hot for some time, which will vary according to the power selected or a dot will be displayed on the and a elements that are still hot. Caution: If the power supply is cut off, when icon will not be displayed it is restored, the even if the cooking zone is hot. [. . . ] If the hob is installed above a drawer, no flammable objects must be stored inside. Use the adequate power for each cooking operation and select the receptacles of a suitable size for the food you are going to prepare. The heat transmission is best when the base of the receptacle and the diameter of the cooking zone are the same size. When you have finished cooking, if you like you can leave the receptacle where it is to make use of the residual heat accumulated. [. . . ]