User manual FAGOR VCE-506

[. . . ] â· This appliance must be used only for domestic cleaning, to vacuum dust and dry dirt from floors, carpets, rugs and other fabrics, as described in these instructions. â· The manufacturer shall not be held responsible for any damage occurring as a result of incorrect, erroneous or irresponsible use and/or for repairs carried out by unqualified persons. â· In the event of breakdown and/or faulty operation, switch off the appliance without attempting to repair it. [. . . ] Replace the filters before picking up fine dust or cleaning new carpets. Do not pick up very fine dust such as cement, very fine sand or flour, etc. Do not use the appliance if there is any obstruction in the airways, as this may dangerously overheat the motor. Before operating the vacuum cleaner, turn the power down to the minimum, using the power setting dial (5), and then select the power you desire. Using the power setting dial (5), you can regulate suction power according to type of flooring, from Minimum (used for curtains and delicate fabrics) to Maximum (for intense dirt and hard flooring). Generally speaking, except in cases of vacuuming extreme dirt or delicate fabrics, it is advisable to use the vacuum cleaner in the intermediate power-saving position between MAX and MIN. Suction power may be regulated manually with the manual air regulator on the handle (12) (Fig. The parquet brush (11) has two operating positions according to the type of flooring (Fig. When finished using the vacuum cleaner, stop it, disconnect it and step on the automatic cord rewind pedal (4). Make sure that the cord winds up straight, helping it with your hand where necessary. Storage: To store the appliance, you may place it in a vertical position, inserting the hook on the telescopic wand into the storage area located in the lower part of the vacuum cleaner (Fig. 6) or hooking the brush into the storage area of the back part of the carry handle (Fig. 7) The nozzles (17) may be kept on the accessories clip (14) on the telescopic wand. To extend the telescopic wand (13) to the desired length, push the catch forward then insert the brush (15), the parquet brush (16) or one of the nozzles (17), then insert the suction hose (11) into the other end of the telescopic wand. 2) Insert the suction hose into the suction hole (1), bringing the suction hose tip (10) and the suction hole together until they fit firmly. Do not pull more cord out when this mark is visible, and never exceed the red mark as this could cause irreparable damage to the automatic cord rewind function. The dust container must be emptied when the filter indicator window turns red while the vacuum cleaner is operating at maximum power and the nozzle is totally free. unplug the appliance and remove the suction hose from the suction hole. [. . . ] At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. [. . . ]