User manual FAGOR TK-600

[. . . ] Do not use the appliance or place any part of it on or near hot surfaces (cooker hobs, ovens, etc. If, for any reason, the appliance stops working, contact an authorised Technical Assistance Centre. Never use any electrical appliance if the cable or plug are damaged, if it is not working properly or if it has been damaged in any way. [. . . ] The kettle can be switched back on again after being allowed to cool down for approx. 2 Functioning with the BRITA filter unit · Submerge the BRITA MAXTRA filter in cold water and gently shake it to remove any air bubbles. Then place the BRITA MAXTRA filter (f) in its housing on the filter support (h), push it down until it firmly fits into the funnel, then position the lid (a) and close it. on placing the filter , check it is correctly positioned in its guide. The kettle may be used filtering the water in the BRITA filter unit, or it may be used directly using tap water and the standard lid. However, we recommend you use the kettle with the BRITA MAXTRA filter to reduce chlorine, scale and impurities in the water, as this gives all the drinks you prepare an improved taste, appearance and aroma. Open the kettle lid by pressing the button (2), and fill it with the desired amount of water. Four bars will appear on the display (b), indicating the recommended filter use time, and a dot will flash in the bottom right corner. If there are no bars but a flashing arrow appears at the top of the display, the filter needs replacing. Place the filter unit (h) inside the kettle and fill it with cold water up to the MAX mark only. Pour away the first two fills, as these are only for rinsing the filter. However, you can also switch the kettle off using the ON/ OFF switch at all times. Note: As a result of its functioning, some Depending on the hardness of the water in your area, after repeated use limescale may form on the inside of the kettle and interfere with its correct working. If this limescale is not removed, it may permanently damage the appliance. Using the BRITA MAXTRA filter will however reduce scale problems in the kettle. In spite of this, any scale in the kettle can be removed using any of the descalers available on the market. Before using the descaler, remove the BRITA MAXTRA filter and replace it when the kettle is totally clean. Repeat the descaling process if there is a lot of scale inside the kettle. [. . . ] For further information, contact your local authority or the shop where you bought the product. Remove the kettle from the connector base and allow it to cool down before cleaning it. Never immerse the appliance or the power base in water and never use highly corrosive or abrasive cleaning agents. [. . . ]