User manual FAGOR TK-500

[. . . ] â· Whenstoringtheproduct, windthe cable carefully around the cable winder provided; otherwise, the cable will be loose. Do not use the appliance or place any part of it on or near hot surfaces (cooker hobs, ovens, etc. If, for any reason, the appliance stops working, contact an authorised Technical Assistance Centre. Never use any electrical appliance if the cable or plug are damaged, if it is not working properly or if it has been damaged in any way. [. . . ] The water level should be between the `MAX' and `MIN' marks. â· Replace the lid and make sure it is properly fitted, otherwise the kettle will not switch itself off when the water boils. After 10 seconds, if you do not set anything, nothing will be displayed on the screen, the kettle will return to standby mode. If you continue pressing one of these ("+" "-") the temperature will rise or fall. Then press the button, the screen will flash continuously and the kettle will go into water boiling mode. If you press again, the LED screen will displayed nothing, the kettle will return to standby mode. â· Otherwise, ifinthefirstinstanceyou press and then the "+" or "-" button to select the desired temperature, the kettle will go into water boiling mode. If you only press the button, the appliance will reach the Otherwise, if the temperature is lower, the element will not function. whilethekettleisheatingthewater , the digits on the screen will flash. When the temperature of the water to be boiled reaches the preselected temperature, these digits will stop flashing. Once you have turned on the kettle, you can select the temperature you wish with the "+" or "-" buttons. The kettle will start the process of keeping the water hot, and this process will continue for a maximum period of one hour. As the process continues, the screen will show a dot at the bottom right. During the keep hot process, if you press the ` ' button, it will come out of the keep hot function and return to the water boiling mode. When the kettle goes into the keep hot mode, the circuit begins to count the time, and after one hour nothing will be displayed on the screen; the kettle will return to standby mode. During the onehour period, if you press the button, nothing will be displayed on the screen and the kettle will return to standby mode. The kettle is fitted with an automatic safety protection device in case of overheating and for when there is no water in the kettle. It is activated if the kettle is turned on when there is not enough water inside, i. If this happens, switch the kettle off at the mains and unplug the cable. Leave to cool for 10 minutes, then refill with cold water and plug the appliance back in. [. . . ] We recommend that you decalcify your kettle once every 4 weeks if used on a daily basis. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. [. . . ]