User manual FAGOR TK-418

[. . . ] Never place the appliance on or beside hot surfaces, for example, radiators, cooking rings, gas burners or similar. If an extension lead is required, use only an earthed cable with a conductor cross-section of at least 1. Interference suppression: this appliance has been interference-suppressed in accordance with the interferencesuppression directives. Electromagnetic compatibility: this appliance has been suppressed in accordance with the EMC (electromagnetic compatibility) directives. [. . . ] Do not use the cable to pull on the plug or pull the plug out of the socket when hands are wet! ⷠOpen the lid and fill the kettle while the lid is open. ⷠCheck the filling level on the water level gauge "d". Note If the kettle was accidentally started empty, the safety cut-out will automatically switch it off. In this case you should remove the kettle from the power base and allow it to cool down for a few minutes. Make sure that the kettle has been filled with an adequate amount of water before using it again. Connect the power base to the mains and position the kettle on the power base. Note If the lid is not properly closed, the kettle will not shut off automatically. Note The ON/OFF switch only operates when the kettle is located on the power base. switching off the kettle · The kettle switches off automatically when the water boils - the red heating control lamp "e" goes off. However, you can also switch the kettle off using the ON/OFF switch "f" at all times. Note The kettle also switches off automatically when it is removed from the power base. No liability is accepted for any damage resulting from use for other purposes, faulty operation or amateur repairs. Operating the appliance for the first time Before using the kettle for the first time, fill it up to the maximum level and boil at least two lots of water. Rinse the kettle out with cold water each time between boiling up these two lots of water. ⷠConnect the power base "g" according to instructions (observe the safety instructions). ⷠPut the appliance into operation (see"Putting into operation"). Switching the kettle back on again · The kettle can be switched back on again after being allowed to cool down for approx. The scale filter under running water and use a soft brush if necessary (no metal). At the latest, the kettle should be descaled when the time required to boil water is markedly longer or if it cuts out too soon while heating the water. [. . . ] For further information, contact your local authority or the shop where you bought the product. Remove the kettle from the power base and allow it to cool down each time before cleaning. Never immerse the appliance or the power base in water and never use highly corrosive or abrasive cleaning agents. ⷠWipe out the kettle and power base with a damp cloth. [. . . ]