User manual FAGOR TK-2006 X

[. . . ] ⷠNever place the appliance on or beside hot surfaces, for example, radiators, cooking rings, gas burners or similar. ⷠIf an extension lead is required, use only an earthed cable with a conductor crosssection of at least 1. Safety instructions when operating the appliance · Never leave the appliance unattended during operation and keep it out of the reach of children! ⷠPersons with nervous disorders should never use the appliance without accompanying person in order to avoid any danger. [. . . ] Do not pull the cable over sharp edges, clamp it into place or allow it to hang down. Do not use the cable to pull on the plug or pull the plug out of the socket when hands are wet! ⷠOpen the lid and fill the kettle while the lid is open (3). ⷠCheck the filling level on the water level gauge "d". Note If the kettle was accidentally started empty, the safety cut-out will automatically switch it off. In this case you should remove the kettle from the power base and allow it to cool down for a few minutes. Make sure that the kettle has been filled with an adequate amount of water before using it again. Connect the power base to the mains and position the kettle on the power base (6). Note If the lid is not properly closed, the kettle will not shut off automatically. Note The ON/OFF switch only operates when the kettle is located on the power base. switching off the kettle · The kettle switches off automatically when the water boils - the red heating control lamp "e" goes off (8). However, you can also switch the kettle off using the ON/OFF switch "f" at all times. Note The kettle also switches off automatically when it is removed from the power base. No liability is accepted for any damage resulting from use for other purposes, faulty operation or amateur repairs. 1 Before using the kettle for the first time, fill it up to the maximum level and boil at least two lots of water. Rinse the kettle out with cold water each time between boiling up these two lots of water. ⷠConnect the power base "g" according to instructions (observe the safety instructions). ⷠPut the appliance into operation (see"Putting into operation"). Switching the kettle back on again · The kettle can be switched back on again after being allowed to cool down for approx. Note As a result of its functioning, some water can condense out of the outlet openings in the base of the kettle and run out over the edge of the power base. [. . . ] Correct separation of waste materials will allow recyclable materials to be re-used. When the appliance is no longer useful, you should cut its cord to put it out of action and dispose of it using a suitable waste elimination procedure. For further information on this matter, consult your local authorities. Remove the kettle from the power base and allow it to cool down each time before cleaning. [. . . ]