User manual FAGOR SP-1235

[. . . ] SP-1235) Interference suppression: The interference of this appliance has been suppressed in accordance with Interference Suppression Standards. Shower, in rooms with damp atmospheres or near liquids (above a washbasin or bath filled with water, for example). [. . . ] For greater protection, we recommend installing a residual current device (RCD) with an operational residual current not exceeding 30 mA. Read the whole of this manual and keep it for further reference, in order to avoid any damage or hazards arising from incorrect use. If you give the appliance to another person, make sure you give them this manual. Keep packaging material and plastic bags out of the reach of children. This appliance is for domestic use only and must not be used for any purpose other than that described in these instructions. The manufacturer holds no liability for any damages arising from incorrect use or from any use other than that described in this manual, or if any repairs are carried out by non-specialised personnel. Do not use the hair dryer in the bath or The hairdryer is equipped with a an overload protection system which switches off the appliance if overheating occurs (e. If the hairdryer switches off during use, turn the switch to "0" and wait for 5 minutes approx. Before using the appliance, check the voltage selected is the same as that of your mains supply. Clean the air inlet grille regularly with a brush, to remove any dust and hair which may have become trapped in the grille. All components must be completely dry before they are fitted back on to the hairdryer. Clean the outside of the appliance with a slightly damp cloth and dry it with a dry cloth. Do not use any aerosols or flammable chemical products on your hair. SP-1830 Cold air button: The cold air button is for reducing the air temperature during functioning, to allow rapid cooling regardless of the switch position. [. . . ] For further information, contact your local authority or the shop where you bought the 0 = Vypnutí 1 = Slabý proud vzduchu 2 = Silný proud vzduchu Volic teploty Volicem teploty si múzete zvolit výkon a tím i pracovní teplotu. O = Vypnutí 1 = Stedná teplota, slabý proud vzduchu 2 = Vysoká teplota, silný proud vzduchu. [. . . ]