User manual FAGOR PRES-05

[. . . ] Before using this appliance for the first time, read the following instructions carefully and keep them for future reference. Children should be watched to ensure they do not play with the appliance. For greater protection, we recommend installing a residual current device (RCD) with an operational residual current not exceeding 30 mA. [. . . ] ⷠBefore installing the barrel, make sure that the barrel has settled long enough to prevent any froth from coming out through the ventilation opening. This could affect the quality of the beer and the barrel could explode. To dispense beer using this device you should acquire the Fagor CO2 accessories as detailed in the description (8 - 4). To dispense beer with this appliance you must purchase the Fagor CO2 accessories, as detailed in the description, from 8 to 4. PRESSURISEDKEG The pressurised beer keg compatible with the FAGOR dispenser and with nozzle type as shown infig. D already contains CO2 and it is therefore not necessary to acquire the optional CO2 accessories. This type of keg does not require installation of the tap or the nozzle provided with the keg for installing on the beer dispenser. 4) into the pressurised barrel adaptor (4) until it is fully locked in, as shown infigureD. Insert the barrel into the dispenser by turning the barrel so that the tubing is Not bent and the flow of the beer is not obstructed (fig. To install this type of barrel, you must purchase Fagor CO2 accessories (ref. Before installing a type B pressurized barrel you must release the excess pressure from the barrel. Rotate the cap a ¼ turn allowing the pressure to leave the barrel, then remove the cap with the help of some pliers and replace it with one of the barrel gaskets (9). Be careful not to bend the metal around the cap, as this could cause air to escape. It is normal for the cap or part of the cap to fall into barrel; this will not affect the taste of the beer. Once the excess gas has been released from the barrel follow the steps outlined in the section "Connecting the CO2 unit. " PRESSURELESSCASK These barrels are fitted with rubber caps (fig. To install this type of barrel you must purchase Fagor CO2 accessories (ref. In case of a non-pressurised barrel, the centre of the cap must be pulled into the inside of the barrel. [. . . ] If you have apressurisedkeg compatible with the Fagor dispenser, proceed as follows: 1. Extract the CO2 unit and turn the 6) and pull the tap handle (2) towards you. To clean the dispenser for this type of keg, follow the instructions given in point for the pressureless cask. [. . . ]