User manual FAGOR PLV-125

[. . . ] The manufacturer will not be responsible for damage which may arise from inappropriate, incorrect or unsuitable use, or from repairs carried out by unqualified individuals. Voltage: 100 - 120 V / 220 - 240 V Frequency: 50 ~ 60Hz Power: 800W Tank volume: 80 cc Selecting voltage: This model may be used with a voltage supply of either 115V~ or 230V~. Before using the appliance, check the voltage selected is the same as that of your mains supply. Prior to using this appliance for the first time, read this instruction booklet carefully and keep it in a safe place for future reference. [. . . ] Should the cable get damaged or need Prevent the cable from touching hot parts of the appliance. For this reason, you must take hold of the appliance by the handle and avoid coming into contact with the metal parts and with the steam. Do not direct the jet of steam at people or animals because it is dangerous to do so. Do not mix together stain-removers or similar products on fabrics which need ironing. When you decide to get rid of the appliance once and for all, you are advised to unplug it and prevent it from being used again by, for example, cutting the power cable. When the LED indicator (9) switches off, the iron has reached the selected temperature. This LED indicator will light up and switch off during ironing indicating the thermostat's cycles. Bear in mind that if you lower the temperature, the LED light (9) will remain off until the soleplate (13) has come down to the selected temperature and, at that moment, it will light up again. Press the spray button (5) to dampen the garment as this makes dry ironing easier. When you have finished, turn the temperature selector to the MIN position and unplug the iron. Let it cool down before proceeding to clean it on the outside and put it away. Warning: For dry ironing, make sure that the steam regulator is always in the dry ironing position. Remove the stickers or protective covering from the soleplate and casing Unroll and straighten out the mains cable. Follow the instructions in the "Selfcleaning" section of part "9 CLEANING AND MAINTENANCE" to make the iron ready for use. Slowly pour the water through the opening for water (3) with the help of a glass (Fig. Note: If the water in your area is too hard ( >27ºF ) we recommend using distilled water. Before ironing with steam, check that the fabric is suitable for this type of ironing. Fill the tank with water (refer to section 6, "Filling the Tank"). If the selected temperature is too low, water may drip from the soleplate. When the LED indicator switches off, the iron has reached the selected temperature. [. . . ] Wait until the LED indicator (9) switches off then on two or three times to make sure that the established temperature has been reached. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. [. . . ]