User manual FAGOR PL-2450 E

[. . . ] Do not use or let any part of the appliance come into contact or near hot surfaces (kitchen gas or electric hobs or ovens). Do not let the cable come into contact with the hot parts of the appliance. This product complies with the European Directives on Electromagnetic Compatibility and Low Voltage. Before using this appliance for the first time, read the following instructions carefully and keep them for future reference. [. . . ] Change the temperature with the screen settings: press the "increase temperature" regulator (6) to raise the temperature from 1 to 3 and to Maximum. To select the right temperature for each item to be ironed, select the correct point and the correct item, which will appear on the LCD screen while you move from one point to the next. Do not put any cleaning products or solvents into the water reservoir. â· Check that the water does not exceed the maximum level and replace the cover (8). : If the water in the area where you live is too hard (>27oF), we recommend that you use distilled water. Do not use battery water or water with added starch, perfume, conditioner, etc. The symbol will appear and the "" symbol will flash when the temperature changes from lower to higher and the "" symbol will flash when you change from higher to lower. When the sole reaches the right temperature, you will hear a beeping sound and the " " symbol will come on. The LCD display (4) will light up for a second, and a beep will sound when it switches off. The display will then show "ACRYL" and the iron will start to heat up. When you hear the beep and the " " symbol appears, the iron is hot and ready to use. If you want to disconnect the iron, hold the "increase temperature" setting (6) down for 2 seconds (Fig. The spray function is also useful to dampen creases created by accident while ironing. : It may be necessary to press the spray button several times to activate this function. When the iron has reached the temperature selected, press the extra steam button (3) while ironing and the steam will come through the holes in the sole (Fig. Wait for at least 5 seconds between each use of the extra steam button so as to allow the iron to heat up again and thereby obtain the maximum amount of extra steam. upright steam: The extra steam function also works when the iron is in an upright position. To use this function, hold the iron upright around 15-30 cm away from the item, press the extra steam button (3), and the steam will come out of the holes in the sole (Fig. CAUTION: Do not direct the iron towards people as the temperature of the steam is very high. The LCD display will light up for a second, and a beep will sound when it switches off. [. . . ] If you do not use the iron on a daily basis, it is a good idea to empty the water reservoir after each use to extend the useful life of the iron. Wind the cord around the support base (do not wind tightly) and store the iron away on its base. Cleaning Unplug the iron and wait until it has cooled down before cleaning it. self-clean This function will remove limescale and minerals accumulating in the steam chamber. [. . . ]