User manual FAGOR NC-2500

[. . . ] Turn the radiator upsidedown on a rug or a soft surface in order to prevent damaging the paint finish. Use the 2 screws supplied with the appliance to fasten the feet in position (fig. Fit the wheels to the spindles on the feet and push firmly until they click into position. [. . . ] This appliance complies with EEC Directive 89/336, relating to electromagnetic compatibility. Switching on Plug it in; move thermostat to highest setting and switch it on as follows: a) on-off units with single heat setting: - key on "I" = ON - key on "O" = OFF b) units with three heat settings: - only right key on "l" = low heat - only left key on "ll" = medium heat - both switches on "l" "ll" = high heat To turn appliance off, switch off both switches or remove plug from wall socket. Adjusting the thermostat The switch and thermostat should be maintained until the desired room temperature has been reached. Now move the thermostat back gradually until the red pilot lamps go out. As soon as the room temperature has dropped below the set temperature, the heater switches itself on automatically until the set temperature has again been reached. In this way the room temperature remains constant with the most economical use of electricity. The appliance will maintain a minimum room temperature of approximately 5°C thus preventing freezing with a minimum energy consumption. 9) To set the heating periods proceed in the following manner: - Check the time by your watch. Turn the numbered dial of the time-clock in a clockwise direction until the number 10 coincides with the reference mark on the time-clock. Set the time period during which you wish the appliance to work by pushing the notches towards the centre. At this point sections will be visible corresponding to the working periods. Set in this way the radiator will function automatically every day during the set period. - To change the programmed time period, just bring back the black notches to their original position and set the new working periods required. Without programmed working periods push all the notches towards the centre. In this case, to turn the appliance off totally the plug must be pulled out apart from switching off, so as to avoid unnecessary working of the timer. Your oil filled raditor is absolutely free from maintenance, fully reliable and will give many years of trouble free service. [. . . ] ⷠDo not use this appliance in rooms having a floor area of less than 4 m2. The appliance is fitted with a safety device which will switch off it in case of accidental overheating. To reset, disconnect the plug from the power for 30 minutes, remove the cause of overheating then plug the appliance in again. [. . . ]