User manual FAGOR MCP-45

[. . . ] Donotpressthedeviceagainsttheskin when using without a comb, as this can cause small cuts. ⷠThe device should not be exposed to temperatures below 0 ºC, or above 35 ºC. Thisdeviceisnotsuitableforuse by individuals (including children) with physical, sensorial or mental disabilities, or who lack the experience or knowledge, unless supervised or instructed regarding the use of the device by a person responsible for their safety. ⷠChildrenshouldbesupervisedto ensure they do not play with the device. [. . . ] If the device does not initially start working switch off and charge the battery for five minutes. Place a towel around the neck of the person whose hair you are going to cut. Seat the person so that their head is at eye level, so you can see better and work more comfortably. If necessary, use books or cushions to raise the person to eye height. Donotcutthesideor the rear of the hair in a straight line; work gradually over the entire head. Before starting, and when working, comb hair regularly in the desired hairstyle. Start cutting When working with the hair clipper for the first time, cut just a small part of the hair until you become familiar with the amount of hair that is cut with a particular setting. After combing hair in the direction of natural hair growth, proceed as follows to achieve a fluid gradual haircut: Step 1. The neck section Use the spacer comb (A), hold the hair clipper with the cutting edge facing upwards and start cutting at the middle, at the bottom of the neck. Press the hair clipper lightly against the head with the teeth of the comb accessory facing upwards. Gradually move the hair clipper upwards, work upwards and outwards through the hair, removing only a small amount each time. Whilst working, gradually move the head of the hair clipper towards you. Then cut the rear section from the start of the neck to above the ears. Side of head Use spacer comb short settings (A) to cut Before starting to cut: Take hold of the device whilst unplugged and adjust the spacer comb (A) as desired, changing according to the cut required. When a different length is required, simply unlock the spacer comb (A) by pressing the clip (B) and slide it to the point desired by moving the spacer comb either upwards or The sides ­ the hair directly above the ears. Then set the spacer comb (A) to a longer length and continue cutting the top of the head. Top of head Use the spacer comb (A) to cut the hair on the top of the head from the back to the front, against the direction of the hair growth. If you observe that the spacer comb (A) is cutting the hair too short, use comb (I). Cut with the hair clipper above the comb, or hold the hair between our fingers and cut it to the length desired. Cut the hair shorter by gradually reducing the distance between the comb, or fingers, and the head. [. . . ] To preserve the environment, do not discard with domestic refuse when the device is at the end of its life. Extract the battery from the hair clipper as indicated in the figures and deposit it At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to adealerprovidingthisservice. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. [. . . ]