User manual FAGOR IFA-90 AL

[. . . ] Installation, electrical connections and grounding must comply with all applicable codes. 3 - Do Not Leave Children Alone - Children should not be left alone or unattended in an area where appliance is in use. They should never be allowed to sit or stand on any part of the appliance. 4 - Wear Proper Apparel - Loose-fitting or hanging garments should never be worn while using the appliance. [. . . ] If any of these sensors senses that the component temperature is above the limit, the power output of the unit will automatically be reduced, allowing the component to cool down. Once this is achieved, the unit will continue to operate normally at the output level set initially by the operator. - Each induction coil is equipped with a sensor which is continuously monitoring the temperature of the bottom of the pan to prevent the pan from overheating. This device will not allow the heating element to turn on unless it senses a cooking utensil on the coil covering enough surface area. the indication that the coil is not running is the flashing of the digital display. Once the pan is put properly on the coil, the digital display will become steady. Note that a small object such as a fork, a spoon, a piece of jewelry, etc. Will not be mistaken for a cooking utensil, and it will not trigger this sensor. Moreover, this device will distinguish between cooking utensils which are and are not suitable for induction cooking. If a cooking utensil which is not suitable for induction cooking is placed on a coil there will be no power output on the coil. - If an operator leans on the keypad by chance for more then ten seconds, controls If a crack appears in the glass surface, disconnect the unit immediately to avoid any risk of electric shock. If the unit is connected directly to supply inside a junction box, then disconnect its breaker, or remove fuses manually. When cooking never use aluminum foil and never place products wrapped in aluminum foil, nor products deep-frozen in aluminum packs on the hob. Aluminum foil could melt and damage vitroceramic glass surface beyond repair. This occurrence is called `long press' and when it happens "-" signs will appear on power displays. The unit will act the same if there is an accumulation of some liquid on the keypad area, or if a damp cloth is left sitting on the keypad. The section will become operational again once the spill or the object/hand is removed, and the element turned back on. In an effort of constantly improving our products, we reserve the right to make any changes to internal components, as well as, to make any(cosmetic) modifications on the outside frame. this unit has been tested and certified under FCC part 15 and CFR Title 47 , Part 18 , for electromagnetic interference. The users with heart pacemakers must consult with the pacemaker manufacturer prior to using this cooktop which incorporates induction heating source. When an induction element - also called: `a heating zone', or simply: `a coil' - is switched on, the appropriate utensil is used, and a desired level of heating power selected, the electronic circuit unit (`induction generator' or `inverter') powers up the induction coil which creates a magnetic field. Medium low heat high moderate heat For simultaneous use, favour the use of cooking zones located on opposite sides of the hob. [. . . ] - Avoid hitting the vitroceramic glass with utensils or any hard objects - the glass surface is highly resistant but not unbreakable. Do not slide them and avoid excessive rubbing of the top, as this leaves scratches and erases the markings . - Avoid leaving any metal cooking accessories , knives and forks , or metal objects on the hob. - Avoid storing flammable products in the cabinets under your cooktop. [. . . ]