User manual FAGOR FUS-6116IT 01-06

[. . . ] For your washing machine to work properly, the mains water pressure must be between 0. A It is recommended that you have a fixed drainage outlet 50 to 70 cm from the floor. This will reduce the noise level and prevent it from moving during use. The electrical installation, plug, socket, fuses or automatic switch and counter must be correctly dimensioned for the maximum power indicated on the specifications plate. [. . . ] The wash options must always be selected after choosing the wash programme. Any programme change during selection cancels the previously selected options. A Spin speed selection and anti-crease button A specific spin speed is associated with the selected programme, and this appears on the display for display models. D Anti-crease option The wash programme stops on the last rinse, with the clothes left in water. When the function is deactivated, the washing machine continues the programme, draining and spin-drying. It is used, for example, when you are not at home and want to delay the spindrying until you get home, to prevent the clothes creasing after spin-drying and being left in the drum to be removed. On non-display models, you can choose a delay of either 3, 6 or 9 hours. cancelling the delay To cancel the delay you have to press the clock button successively. The delay will be cancelled when 24 hours have been reached and the button is pressed once more. B By pressing the button several times you can choose between several combinations of one, two and up to three additional functions at the same time depending on the programme selected. Button: Easy-iron ( ) This option prevents garments from creasing by means of carrying out a special programme with special turns to fluff out the garments after spin-drying and make them easier to iron. Button: Extra rinse ( ) Increases the level of the final rinse obtained in the clothes; suitable for large loads and garments belonging to people with sensitive skin. Button: Intensive wash ( ) This option, specially recommended for heavily soiled, stained clothes, achieves better results by extending the normal wash cycle. If during the additional function selection, the programme is changed or the ON/OFF button is pressed, all the functions selected until then are cancelled. On display models the minutes remaining until the end of the wash are displayed throughout. The various buttons can be blocked to prevent them from being pressed and affecting the selected wash programme and options. The block function should be activated after the wash programme has been selected together with all its options. Activating the block function a The block function is activated by pressing the start/pause button and holding it down for at least 3 seconds. Deactivating the block function b The block function is cancelled when the wash programme comes to an end. If you want to deactivate the block function before the end of the programme, you have to hold the start button down again for at least 3 seconds. After 3 seconds, the block function indicator will disappear from the display, and it will go into pause status. On display models, when the programme is running, the phase the programme is at will appear on the display together with the time remaining before the programme ends. [. . . ] Initial water temperature, size of load or unbalance caused by the garments during spin drying. When this happens a number of other indicators appear on the display: F05, F06, . , F10 or the wash, rinse and end pilot lights will flash, together with one of the other control panel pilot lights. When your appliance is of no further use, it should not be disposed of together with general domestic waste. [. . . ]