User manual FAGOR CR-20

[. . . ] Children should be watched to ensure they do not play with the appliance. This product complies with the European Directives on Electromagnetic Compatibility and Low Voltage. Before using this appliance for the first time, read the following instructions carefully and keep them for future reference. Make sure that the mains voltage in your home corresponds to that indicated on the appliance. [. . . ] Before using the coffee machine for the first time, wash the filters (15 and 16) the measuring spoon (14), the water reservoir (2) and the steam nozzle (12) with soapy water. To do this, fill the reservoir with water and operate the machine without coffee several times (following the steps in section 6. Once the coffee machine is clean, set the machine on a dry, firm, stable surface. Open the water reservoir lid (1) and fill with fresh, clean water up to the MAX mark. When the pilot light (7) stops flashing, the machine is at the correct temperature and is ready to make coffee. Warm the cups: Place the cups upside down on the cup warming plate (3). Level, turn the function selector (6) to the position and the flow of coffee will stop. Do not remove the cups until the coffee has completely stopped flowing. The unit must be manually switched off to avoid overflowing, splashing and possible danger or injuries. â· When you have finished using the coffee maker, place the I/0 switch (17) in the "0" position to switch off the machine, then unplug the appliance from the power point. Make sure that the coffee maker is cold before doing any cleaning or maintenance. When the unit is cold, remove the filter holder (9) from the upper filter head (8) and holding the closed part of the filter forwards, empty the used coffee. Once the coffee machine is ready, select one of the filters (15 or 16), place it in the filter holder (9) and measure the desired quantity of coffee into it (fig. D): - One small coffee: Place one spoon of ground coffee into the filter for small coffee (16) - One large coffee: Place two spoons of ground coffee in the filter for two cups of coffee (15). - Two cups of coffee: Place two spoons of ground coffee in the filter for two cups of coffee (15). We recommend you use the measuring spoon (14) to obtain the correct measure for one cup. E) and always remove any excess coffee from around the edges of the filter. Never overload the coffee above the level of the edge of the filter to ensure the filter holder closes correctly without force to avoid leaks. Place the filter holder (9) in the upper filter head (8) and turn it firmly from left to right as shown in figure H. place one or two preheated cups on the drip grille (11) , under the filter holder outlets (9). When the machine has warmed up and the indicator light (7) has stopped flashing, turn the function selector (6) to the position and the coffee will begin to emerge (fig. When the cups are filled to the desired A cappuccino is an espresso coffee, topped with frothed milk. [. . . ] To remind you that you must collaborate with a selective collection scheme, the symbol shown appears on the product warning you not to dispose of it in traditional refuse containers. For further information, contact your local authority or the shop where you bought the product. "Preparation for start-up" When the indicator light (7) is fixed on, push the hot water button (4). When the hot water indicator light (4) stops flashing and remains on, the machine is at the correct temperature to generate hot water. [. . . ]