User manual FAGOR CR-18

[. . . ] ⷠBefore switching the appliance on, fill the deposit with water. ⷠThe drip tray and the grille must be correctly fitted before switching the coffee machine on. When closing the control lever, take care not to put your hands in the filter holder. Tray for cups Water deposit Control lever ­ Open/close system Pilot light 0 / I and temperature Filter holder On / off switch Coffee switch Drip grille Drip tray Filter 1 measure of coffee / 1 weak measure Filter 2 measures of coffee / 2 weak measures Filter for capsules, "E. [. . . ] Select the filter depending on the type of coffee you are going to prepare remembering that: - Filter (J) for one cup 1 measure of coffee: one slightly rounded measure of coffee (N) (Fig. 6) - Filter (L) for 2 cups 2 measures of coffee: two slightly rounded measures of coffee (N) (Fig. Once pressed, the level must be below the maximum level indicated inside the filter - Put the single weak measure in using the coffee measurer (N) 4. Before using the coffee machine for the first time, clean the filters with water. To do this, fill the deposit with water and run it through without coffee until the deposit is empty. Remove the deposit to fill it with cold water and fit it back in the coffee machine (Fig 2). ⷠThen lower the control lever until it locks down (Fig. Plug in the coffee machine and switch it on using the on / off switch (F). The pilot light (D) will come on showing a red light whilst the coffee machine is heating up. ⷠPosition a container under the coffee outlet and move the switch (G), to the position so that the water starts to Clean off any coffee which can remain on the top part of the filter holder (E). Close the system by lowering the control lever (C) until it locks down completely (Fig. When the pilot light (D) turns green, move the switch (G) to the position for it to be able to start dispensing. When you have finished using the coffee machine, put the switch (F) on "0" and unplug the coffee machine at the socket. Preparing hot drinks In order to heat liquid, you must follow these steps: 1. Move the switch (F) to the "I" position and the pilot light will come on red. Close the system by lowering the control lever (C) until it locks down completely (Fig. When the pilot light turns green, turn the steam regulator (Q) to the steam position The pilot light (D) will turn red whilst the steam regulator is open. Note: At first only water will come out of the steamer so it is advisable to have a container to hand to collect the water. When steam starts to come out, close the steam vapour momentarily (Q), insert the accessory for cappuccino (S) in the liquid which you wish to heat and open the steam regulator (Q) again positioning it on 6. When the chosen temperature has been reached, close the steam regulator (Q). Remove the steamer (R) from the container and put it on the drip grille (H). To prepare a cappuccino you must: · Approximately 3 cm into the milk and hold it in this position. [. . . ] ⷠTurn the coffee outlet (P) clockwise until it comes away from the from filter holder (E), (Fig. ⷠIf necessary, put the switch (G) in the position and let the water flow for a few seconds to clean inside the filter holder (E). ⷠFit the coffee outlet (P) in the filter holder (E) and turn it anti-clockwise until it locks completely. Do this in the following way: - Put the on / off switch (F) on "0" and unplug the cable from the socket. [. . . ]