User manual FAGOR CR-15

[. . . ] Children should be watched to ensure they do not play with the appliance. For greater protection, we recommend installing a residual current device (RCD) with an operational residual current not exceeding 30 mA. This product complies with the European Directives on Electromagnetic Compatibility and Low Voltage. Before using this appliance for the first time, read the following instructions carefully and keep them for future reference. [. . . ] The heater contains a heating element with thermal fuse and protection against self-burning in the event of becoming dry. Before using for the first time the following accessories should be washed in warm non-abrasive soapy water and thoroughly rinsed: water tank (11), filter holder (4), filter (14), dosage spoon (13) and steamer (7). To do so, fill the tank (11) with water and operate the appliance without coffee several times in a row. Fill the tank (11) with fresh clean water until the MAX mark, and replace it in the coffee maker. The red indicator light (2) will turn on to indicate that the coffee maker is connected. When the green indicator light (3) turns on, the coffee maker has achieved the working temperature and is ready to make coffee. Place one or two cups on the drip tray (6), under the coffee outlets in the filter holder (4). Wait until the coffee has stopped dripping before removing the filter holder (4). ⷠAfter each use, remove the filter holder (4) and - pushing the filter fastener forwards - empty out the used coffee (fig. When you have finished using the coffee maker, press the I/0 switch PREPARING CAPPUCCINO to the 0 position to switch-off the appliance, and unplug the unit from the mains. When the coffee maker is warm, the plate will heat up the cups placed on it. ⷠOnce you have setup the coffee maker, make an espresso coffee (see the section on "Preparing an espresso coffee"). ⷠFill a tall stainless steel vessel approximately 1/3 full of cold skimmed milk. The milk must be cold and the vessel must have been refrigerated, therefore it should not be submerged in hot water. ⷠInsert the steamer (7) in the milk that is to be warmed up and turn the function selector dial (10) to the position (fig. This will allow the vapour to mix with the air and create creamy froth. The froth should be thick with compact bubbles to produce good taste and lasting consistency. ⷠOnce you have finished creating froth, turn the function selector dial (10) to the · Pour the frothy milk onto the espresso coffee and fill the cup to the top with the remaining milk. Having setup the coffee maker, when the green indicator light turns on (3) place the filter (14) in the filter holder (4) (fig. we recommend you use the dosage spoon (13) provided to measure one cupful (7g). Press the coffee down in the filter (14) with the underside of the dosage spoon (13) and remove any coffee spills from the edge of the filter holder (4). ⷠPlace the filter holder (4) in the discharge head, rotating it firmly from left to right (fig. [. . . ] Refill the water tank; correctly install the tank; use freshly ground coffee. Refill the water tank; correctly install the tank; clean the filter holder and use a more thickly ground coffee; descale the machine. The steamer system is Clean the steamer; use fresh blocked; or the milk isn't milk; use cold milk; refill the fresh; or the milk isn't cold; or water tank. The ground coffee is not firmly compacted; or the amount of coffee is not sufficient. [. . . ]