User manual FAGOR CR-1000 2008

[. . . ] Allow it to cool down before fitting and removing its different parts and before cleaning it. Do not expose the coffee maker to the elements (rain, sunlight, ice, etc. Do not use or place any part of this appliance on or near hot surfaces (gas or electric hotplates, ovens). do not allow the cord to hang over the edge of the surface it is placed on. [. . . ] â· The carafe is designed for use with this coffee maker only. Do not place the carafe on or near hot surfaces (stoves, ranges, cooker hotplates, hot ovens, microwaves, etc. This appliance should not be used by physically, sensorially or mentally handicapped people or people without experience or knowledge of it (including children), unless they are supervised or instructed in the use of the appliance by a person responsible for their safety. â· Children should be watched to ensure they do not play with the appliance. â· For greater protection, we recommend installing a residual current device (RCD) with an operational residual current not exceeding 30 mA. Take the lid off the water tank and fill it up with the desired amount of water (2 cups minimum and 4 cups maximum). Place the desired amount of ground coffee for 2 or 4 cups in the filter (observe the marks on the inside of the filter). Fit the filter holder onto the coffee maker in the direction of the arrows and turn it to "OK" position (fig. The appliance will take a few minutes to reach the correct temperature. When all the water has gone, turn the function selector to "0". Wait for approximately 2 minutes before removing the filter holder from the appliance. Before using the coffee maker for the first time, carefully clean all the removable parts with warm water and detergent (the filter, filter holder and glass carafe with its lid). To clean the inside of the coffee maker, run it twice without any coffee in the filter. Fill the water tank with the amount of water for the desired number of cups of coffee, and add 1 or 11/2 more cups of water to make steam. Fill a tall, narrow container (preferably metal) half-full of very cold low-fat milk. Place the steam pipe (c) in the container, with the steam nozzle (d) submerged about 2 cm in the milk, without touching the bottom of the container. Turn the function selector to a position within the steam adjustment field, between the symbols and (fig. When it has finished frothing up the milk, turn the function selector to "0" (fig. Unplug the appliance and turn the function selector to to expel any steam left in the tank. Clean the steam pipe (c) and the steam nozzle (d) with a damp cloth after each use. [. . . ] To remind you that you must collaborate with a selective collection scheme, the symbol shown appears on the product warning you not to dispose of it in traditional refuse containers. For further information, contact your local authority or the shop where you bought the product. Clean the removable parts with warm water and dry them carefully before replacing them again. Cleaning the steam nozzle: Clean the outside of the steam pipe with a damp cloth immediately after use. [. . . ]