User manual FAGOR CG-806

[. . . ] ) should be kept out of the reach of children, as they could constitute a safety hazard. In the event of their use being absolutely necessary, always ensure that they conform to current safety standards, and take care not to exceed the indicated maximum voltage level. ⷠThe electrical safety of your appliance is only guaranteed if it is connected to an efficient earth installation, as stipulated in current electrical safety regulations. [. . . ] Before using for the first time, familiarise yourself with all the components. 3) and clean along with the jug itself and the permanent filter (3) in warm soapy water. Dry thoroughly and replace, fitting the filter-holder into its place and the lid onto the jug. To clean the inside of the appliance, run a coffee-making cycle twice without adding ground coffee to the filter. To do this, follow the instructions given in the section entitled "Making coffee". ⷠFill the filter (3) with the required quantity of ground coffee and close the lid. After using the coffeemaker a few times, you may wish to adjust the amount of coffee used according to individual taste. Ensure that the jug lid opens the anti-drip value (6), otherwise the filtered coffee will not drip down into the jug and will overflow from the filter. The liquid that drips into the jug is hot and may cause burns if the jug is accidentally broken. To avoid breakage, take the following safety precautions: · do not allow all the liquid to evaporate. ⷠDo not use a broken jug or a jug whose handle is loose or weak. A tiny crack or breakage of a small piece of the glass may cause the jug to shatter and to contaminate the liquid with splinters of glass. ⷠDo not clean the jug with an abrasive scourer or any cleaning products that may scratch or otherwise weaken the glass. Do not place it on or near hot surfaces (heaters, burners, hobs, hot ovens, microwaves, etc. When the filtering process is completed, the heater plate will keep the coffee warm. ⷠIf you wish to pour a cup of coffee before the filtering process has finished, remove the jug from the heater plate, pour and then replace immediately. ⷠWhen the jug is empty, turn the start/stop switch off (the pilot light will go out), unplug the appliance leave to cool for 10 minutes before repeating the coffee-making operation or cleaning. ⷠTo prevent the water in the filter from overflowing the jug lid should be correctly fitted in order to ensure that the anti-drip value is opened, enabling the water to pass through to the jug. [. . . ] Depending on the hardness of the water in your area and the frequency of use, the appliance's tubes may become obstructed by lime. You will know that this has occurred when the filtering process starts taking longer than normal. To prevent this, you should decalcify your coffeemaker by either using a commercial decalcifying agent specially designed for coffeemakers, or by following the instructions given below: Fill the jug with a 1/4 vinegar 3/4 water solution. [. . . ]