User manual FAGOR CG-406

[. . . ] ⷠDo not allow children or disabled persons to handle the appliance unsupervised. ⷠDisconnect the appliance from the mains when not in use and before cleaning. Wait until the appliance has cooled down before assembling or dismantling parts and before cleaning it. ⷠDo not leave the appliance exposed to the elements (rain, sun, ice, etc. [. . . ] Contact an authorised Service Centre and ask for original accessories and parts to be used. In the event that you decide to dispose of the appliance definitively, it is advisable to disable it by cutting the power cord, after having unplugged it from the socket. Before using your coffee maker for the first time, familiarise yourself with all the parts. 2 & 3) and the jug lid (5) (as indicated in Figure 4 for CG-314, CG-406, CG-412 and consult Section 7 "thermal jug" for CG-416 TH) and clean them together with the jug (6), the permanent filter (10) and the anti-drip support valve in lukewarm soapy water. Rinse well, dry and reassemble them, attaching the anti-drip support valve correctly to the filter holder. ⷠTo clean inside, operate the coffee maker twice in succession without placing ground coffee in the filter. For this process, follow the instructions under the section entitled "Preparing the coffee". Fill the filter (10) with the desired amount of ground coffee and close the lid. After using the coffee maker several times, you may adjust the amount of coffee to taste. Make sure that the jug lid opens the anti-drip valve, otherwise the filtered coffee will not filter through to the jug and will overflow out of the filter. ⷠDo not use a broken jug or one with a loose or weakened handle. Any crack or chip could break the jug or contaminate the liquid content with glass shards. ⷠDo not clean the jug with any abrasive scourer or cleaner which might scratch or weaken the glass. Do not place the jug on or near any hot surface (heater, burner, cooking hotplate, hot oven, microwave oven, etc. With model CG-314, CG-406, CG-412, when the coffee is made, the coffee jug will remain hot due to the thermostat cycle to activate the water heater (7). ⷠWith model CG-416 TH, the thermal jug (11) will keep the coffee hot even when you switch off the coffee maker. When the jug is empty, unplug the appliance from the mains and wait approximately ten minutes for the coffee maker to cool down before making more coffee or cleaning it. Turning this control (8) allows you to adjust the flavour of the coffee, varying the strength of the coffee. [. . . ] To do so, you may use specific limescale removers on the market especially designed for coffee makers or else follow the following procedure: · Fill the jug with one-part vinegar and three parts water. ⷠRepeat this operation two or three times, depending on how much limescale there is in your coffee maker. ⷠAfter you have removed the limescale, operate your coffee maker two or three times with just water so as to remove any vinegar left behind. ⷠWe recommend that you remove the limescale from your coffee maker every four weeks. [. . . ]