User manual FAGOR CFT-90BEPOCA

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FAGOR CFT-90BEPOCA. We hope that this FAGOR CFT-90BEPOCA user guide will be useful to you.


FAGOR CFT-90BEPOCA : Download the complete user guide (269 Ko)

Manual abstract: user guide FAGOR CFT-90BEPOCA

Detailed instructions for use are in the User's Guide.

[. . . ] Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. [. . . ] The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. 8 - OFF lamp button 9 - ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. When washed in a dish washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. The metal grease filters must be washed at least once a month and anyhow whenever the LED 4 indicates the saturation of the filter (see page 13). This LED flashes to warn you that the metal grease filters must be cleaned. Once the grease filters have been cleaned, press button 1 for about3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. Remove the filter using the handles designed for this purpose by pulling the filter backwards and then downwards (Fig. Let the filter dry without damaging it before putting it back into place. Carry out the above steps in reverse order to put the filters back after having washed them. Children should not be allowed to tamper with the controls or play with the appliance . -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. [. . . ] D) If the charcoal filters have already been installed (covering the grates protecting the rotor on the motor) and must be replaced, turn the central handle in the counter-clockwise direction until the filters are unlocked. To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Clean the external surface of the cooker hood almost once every 10 days. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE FAGOR CFT-90BEPOCA




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FAGOR CFT-90BEPOCA will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.