User manual FAGOR CC-70D

[. . . ] Extreme precaution must be taken when using any type of heater close to children or disabled people and when in operation, the appliance should not be left unattended. Do not let the cable make contact with sharp surfaces or be squashed by heavy objects. First, turn the appliance off, grab the plug and remove it from the socket. Do not use it to defrost pipes or prevent them from freezing; do not hang clothing on it to dry. [. . . ] In order to avoid an electric shock or blowing the fuses, make sure that no other appliance is using the same socket. Any other use not recommended by the manufacturer could cause a fire, electric shock or other physical damage to people. Avoid the use of extension cables because they can overheat the heater and cause a fire. The appliance will not operate if it is not resting appropriately on the ground. IMPORTANT: Never cover the appliance whilst it is working as it could cause dangerous overheating. The appliance has a safety switch located on the base which prevents the appliance from working if it falls accidentally. For the safety switch to operate, the appliance must be resting on a firm and stable surface. Make sure that the heater is on a horizontal and stable surface before plugging it into the power supply. the screen mode indicator (c) will show which mode has been selected. Every time this button is pressed, the selected speed will vary following the sequence in figure 3. When this button is pressed the selected temperature will appear, which is 23 ºC by default. You can select from 18 ºC to 35 ºC and the frost function following the sequence in figure 4. A few seconds after selecting the temperature, the screen will show the ambient temperature again. The heater will be connected until the desired temperature is reached and then The temperature control can be disabled by pressing the button until the temperature symbol (e) disappears. Button once Frost watch function: After adjusting the frost watch function as explained in the "Temperature function" section, the heater will remain disconnected unless the temperature drops below 4ºC. If this occurs, the frost function will connect the heater cycle automatically to stop ice forming on the appliance. Press the timer button; the time adjustment will then appear on the screen in hours and minutes along with the timer symbol (f). Warning: By default, the time is 0 and if there is no adjustment at that time, the timer symbol (f) will be substituted by the continuous symbol (a) in a few seconds. [. . . ] At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. To remind you that you must collaborate with a selective collection scheme, the symbol shown appears on the product warning you not to dispose of it in traditional refuse containers. [. . . ]