User manual FAGOR BV-2006 NX

[. . . ] The manufacturer shall not be responsible for any damages that may arise from improper or inadequate use, or for repairs conducted by nonqualified personnel. Keep the appliance separate from water or other liquids, to avoid electric shock; do not connect the appliance to the mains if it is on a damp surface. Do not allow children or the disabled to handle the appliance unsupervised. [. . . ] if the cable for this appliance is damaged , contact an authorised Technical Assistance Service for it to be replaced. Do not leave the appliance exposed to the elements (rain, sun, ice, etc. Do not use or let any part of the appliance come into contact or near hot surfaces (kitchen gas or electric hobs or ovens). Do not let the cable come into contact with the hot parts of the appliance. Do not remove the jug from the motor base when the appliance is functioning. Do not place your hands or any objects in the jug when the blender is functioning. If necessary, disconnect the appliance and use a spatula to remove any food stuck to the walls of the jug. Screw the bottom part of the glass jug (3) onto the joint (6) and turn it anticlockwise (fig. To dismantle the blender, to clean it for example, carry out the assembly process in reverse order. Before plugging in the blender, make sure the jug is correctly fitted and in place on the motor base (7). NOTE: The blender has a safety lock system to ensure the appliance can only be connected if the accessories are correctly fitted to the unit. Open the lid (2) or the dispenser cap (2) by turning them clockwise and pour the food or drink for blending into the jug. You may adjust the rotation speed or make a quick selection, depending on your requirements: · Speed regulator: Select the speed by turning the dial (8) between MIN and MAX, if you wish to control the rotation speed yourself. The pilot lights will light up until the selected position is reached and the indicator lights on the three buttons will switch off (fig. Quick select: Press one of the three quick select buttons, depending on your requirements. Before using the blender for the first time, clean the dispenser cap, jug lid, jug and blade in warm soapy water and dry them thoroughly before assembling them again. ASSEMBLY Unplug the appliance before carrying out any dismantling or assembly operations. If you wish to stop it before this time has elapsed, press the button again. [. . . ] For further information, contact your local authority or the shop where you bought the product. Pour water and a little detergent into the jug and press the "Pulse/Auto Clean" button. Dismantle the blender by carrying out the assembly procedure in reverse order (see the "Assembly" section). [. . . ]