User manual FAGOR AF3-607 X

[. . . ] Check that this, once installation is completed, is not obstructed and that there is sufficient space so that the purified fumes and steam can return easily into the kitchen. Check that the lateral wall units between which to install the hood are sufficiently robust for installing the hood. Otherwise mount the hooking brackets on the wall (*) to use as additional supports: a. Insert each bracket from the rear inside the hood through the apposite slots (Fig. [. . . ] Note: the position of the brackets can be adjusted during installation, suitably loosening and retightening the screws that fix them to the hood. The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) or is not easily accessible, place a standards approved bipolar switch that provide full disconnection under overvoltage category III conditions, in accordance with the wiring rules. Attention: substituting the supply cable must be carried out by the authorised technical assistance service. Put perforation diagram N3 on the REAR of aesthetic panel J (the arrow on the diagram turned upward towards the UPPER EDGE of the aesthetic panel). 6 Put the steam collector over the aesthetic panel and fix it with 8 screws L. 6 Remount the door on the hood, first on upper guides M1, then on the lower M2. 6 Close completely and re-open the door to check its correct sliding on the guides. Same frequency with which you carry out maintenance of the fat filters) internally and externally. Cover the grill that protects the suction motor with the carbon filter so that the slots on the filter correspond to the pins on the sides of the motor protection grill. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. The cooker hood should be cleaned regularly (at least with the Never use the hood without the grill mounted!This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. The premises must have sufficient ventilation when the kitchen hood is used at the same time as other apparatuses fuelled by gas or other fuels. The sucked air must not be conveyed in a conduit used for discharging fumes produced by apparatuses fuelled by gas or other fuels. cooking on the flame under the hood (flambé) is strictly forbidden. [. . . ] cooking on the flame under the hood (flambé) is strictly forbidden. The use of open flame damages the filters and can cause a fire; it must therefore be avoided in any case. Frying must be carried out under control in order to prevent overheated oil catching fire. Keep strictly to the regulations envisaged by the competent local authority as far as the technical and safety measures to adopt for discharging fumes are concerned. [. . . ]