User manual FAGOR 9CFB61

[. . . ] -- You should never "flambé" dishes under the hood or operate gas rings under the hood without placing cookware on them (the flames sucked up into the hood can damage the appliance). -- When frying food under the appliance, you must carefully monitor the preparation at all times. -- The hood should never be used over a combustible fuel burning stove (wood, coal, etc. -- Never use steam or high-pressure devices to clean your appliance (requirement imposed by electrical safety). [. . . ] During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The electrical connections are made before the appliance is installed in its housing. Ensure that: -- the electrical installation has sufficient voltage, -- the electrical wires are in good condition, -- the diameter of the wires complies with the installation requirements. This appliance is delivered with a H 05 VVF power cord that has three- 0. It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the power cable is damaged, call the aftersales service department in order to avoid danger. If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. Fixing to the wall : -- Mark a vertical line on the wall centred on the cooktop. -- Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance. -- Before fixing the hood, mount the nonreturn valve on the motor outlet -Secure the hood's fixing support, ensuring that it is perfectly level. 3) -- Fit and secure the body of the hood on this support with the screws provided for this purpose. 1) -- Mark the two holes accordingly -- Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed on the same axis as the hood (part B Pic. -- Lift the upper duct up to the ceiling and fix it to the bracket using the screws. -- Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed in the same axis as the hood. -- Lift the upper duct up to the ceiling and fix it to the bracket using the two screws. [. . . ] You should order these filters from your dealer (quoting the reference shown on the identification plate located inside the hood) and note the date the filter was changed. To preserve your appliance, we recommend that you use Clearit cleaning products. Professional expertise serving individuals Clearit offers you professional products and solutions designed for the daily care of your household appliances and kitchens. They are on sale at your regular retailer, along with a complete line of accessories and consumable products. [. . . ]