User manual FAGOR 7CFT-NERO ISL

[. . . ] Any frying must be done with care in order to make sure that the oil does not overheat and burst into flames. As regards the technical and safety measures to be adopted for fume discharging it is important to closely follow the relations provided by the competent authorities. The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH, it is in any event necessary to proceed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions as concerns hood and filter cleaning will lead to the risk of fires. [. . . ] Using a pencil, draw a line on the wall, extending up to the ceiling, to mark the centre. Rest the drilling template against the wall: the vertical centre line printed on the drilling template must correspond to the centre line drawn on the wall, and the bottom edge of the drilling template must correspond to the bottom edge of the hood. Place the lower support bracket on the perforation diagram making it coincide with the traced triangle, mark the two external holes and perforate. Remove the perforation diagram, insert two wall-dowels and fix the support bracket of the hood with two 5x45 mm screws. Using a pencil mark the cooker hood permanent drill hole inside the suction group (1 or 2 fixing points are necessary for permanent mounting). Apply the flues support bracket , , G" to the wall adherent to the ceiling, use the flues support bracket as a perforation diagram (if present, the small slot on the support must coincide with the line drawn previously on the wall) and mark two holes with a pencil. Fix the hood into its final position on the wall (ABSOLUTELY ESSENTIAL). If the hood is to be used in ducting version, the other end of the pipe must be connected to a device expelling the fumes to the outside. If the hood is to be used in filter version, then fix the deflector F to the chimney support bracket G and connect the other extremity of the pipe to the connection ring placed on the deflector F. Apply the chimney stacks and fasten them at the top to the chimney support , , G" (20b) using 2 screws (20a) 21. Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood. The standard period of time is 5', at the end of which the hood reverts to speed level 2. To deactivate the function before the set time has elapsed, simply press the "-" button. SPECIAL FUNCTIONS Programming the Clock The clock may be set at any time, apart from when the timer function is active. The clock may be displayed in a 12-hour format, indicating a time between 1:00 and 12:59. The clock may be reset by pressing and holding the "Timer" button for 5 seconds, then pressing the "-" and "+" buttons to adjust the time. The user may increase/decrease the time in steps of 1 minute; however, if the "-" or "+" button is pressed for 1 second, the time is decreased/increased in steps of 5 minutes. In this case, the control panel rounds the time off to the nearest 5 minutes. The user can end the clock resetting stage by pressing the "Timer" button. If none of the buttons are pressed for 1 minute, the control panel accepts the set value and adds on 1 minute, then begins to operate normally. Grease filter warning After 40 hours of operation, "Grease Filter" appears on the display. To reset the grease filter warning, the user should press and hold the "+" button for 5 seconds. [. . . ] Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. [. . . ]