User manual FAGOR 7CFG-60P

[. . . ] Over horizontal areas, if any, the duct must be slanted out about 10% upwards of the hood in direction towards the outside. Note -- The shorter the exhaust duct is and the fewer bends there are in it, the more effective will the cooker hood be. When using the exhaust version, follow these rules: Do not connect the exhaust hood to chimneys, flues and air ducts serving the room. [. . . ] Installation The hood is designed for installation in kitchen cabinets and must be mounted over the center of the cooking area. The minimum distance between the cooking area and the under part of the hood must be 650 mm. Note -- The distance, however, is subject to the safety rules in effect in the various countries. To install the hood please consider the following dimensions: GR04N GR 04N-TWIN 50 = 467 x 259 mm 60 = 507 x 259 mm 90 = 687 x 259 mm 1. Prepare a hole for a tube of 105 or 130 mm diameter according to the provided spigot. Take out the grille from the hood (see description for changing the grease filter) and place the appliance under the opening. Insert the appliance into the cupboard and fix it in the drillholes by means of the four provided screws (Fig. Electric connection Make sure the supply voltage ratings correspond with those stated on the appliance rating label. Attention: If the appliance does not have a plug, when making a fixed installation, a cutoff device must be used to assure The cutoff distance of the contacts must be at least 3 mm. Operating instructions The hood has the following controls: 3/1 speed switch 3/2 light switch Maintenance Note -- When performing maintenance operations, disconnect the plug from the socket. Vapours and odours in the air are exhausted first through the grease filter and then (if the hood is in filter version) through the odour filter. The efficiency of the appliance depends on the condition of the filters. Grease filter This absorbs vapour-suspendend grease particles and protects the kitchen and furniture from greasy residues. Acrylic It can be washed at more or less frequent intervals depending on how often the hood is used. To do so, wash the filter by hand In warm soapy water (do not wring the filter, press it in a cloth to dry). Special paper (not washable) with red diagonal lines on the top of the sheet. [. . . ] In order to change the carbon filter it is sufficient turn counter clockwise (Fig. Clean the outside of the hood with a sponge soaked with liquid neutral detergent or with a cloth soaked with denatured ethyl alcohol. If the lamps fail to light when operating the switch, make sure they are screwed in before calling a technician. [. . . ]