User manual FAGOR 7CFE-130IX

[. . . ] The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. The manufacturers will not accept liability for any problems however caused by the failure of the user or installer to comply with these instruction or with safety regulations. it is recommended that installation is carried out by a qualified electrician. [. . . ] When installed, the distance between hood and burners must be not less than 65 cm. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. It is advisable to call a qualified technician to make the electrical connection. If you intend to connect it directly to the electric mains, remove the plug and fit an approved bipolar switch with a minimum contact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. -- We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. slider switches panel Two are the switches: one for lighting ON and OFF the lamps; one for lighting ON and selecting suctions power. With speed selected, closing the steam deflector switches off the hood. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. When washed in a dish washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. 8 - the grease filter is fixed to the extractor grille with clips which unfasten to allow extraction of the filter). After cleaning the metal grease filter, remount in reverse order, making sure the entire extraction surface is covered. Let the filter dry without damaging it before putting it back into place. [. . . ] D) If the carbon filter is already mounted and needs to be removed, turn anticlockwise until it unlocks. To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Clean the external surface of the cooker hood almost once every 10 days. [. . . ]