User manual FAGOR 5CFB-30X

[. . . ] * The air sucked can't be vented through or into a duct used to let out fumes from appliances fed by energy other than electric power (eg. * To evacuate the air outlet, please comply with the pertaining rules given by competent authorities. *Ensure the room has adequate aeration when a range hood and appliances fed by energy other than electric power (gas-, oil-, or coal- stoves, etc. [. . . ] Do not use uncovered electric grills In order to avoid possible fire risk, all instructions for grease filter cleaning and for removing eventual grease deposits should be strictly followed. The appliance is already arranged both for filtering and for suction performances. 1), the air and fumes vented by the appliance are depured both by a grease filter and by an active coal filter, and put again into circulation through the side-grids of the chimney. For this version an air deflector placed on the superior part of the pipe and allowing airrecycling is necessary (Fig. 2), fumes are directly vented outside, through an evacuation duct connected with the superior part of the wall or the ceiling. * Before installing the appliance and in order not to damage the appliance itself, the metal grease filter should be removed. Such filter can be removed by pushing the special filter handle toward the back side of the range hood and turning it downwards so as to unfasten it from its slot (Fig. 4X), perforate the wall according to the pattern indicated by the jig itself, and pay attention in order not to damage water pipes and electric wires. 4S) can be applied by using the screws provided with the equipment (Fig. 5) and then adjust horizontally and vertically the position of the appliance by adjusting the special metric screws (Fig. After the appliance is adjusted, fix it by inserting and tightening the safety screws properly (Fig. Fixing the ornamental chimney * Before fixing the chimney, place the electric feeding equipment into the ornamental pipe and provide a hole for the air outlet if the appliance is used in its sucking version. Before connecting the flexible exhausting pipe to the motor, make sure the stop valve, which is on the air outlet of the motor, can swing. 7Y) to the wall or ceiling by using the proper reinforcements and screws in equipment. Connect the range hood flange with the evacuation hole by using a proper pipe. Now mount the inferior chimney by inserting it through the front side of the range hood and then turning it down until it is fixed inside (Fig. [. . . ] Once the burnt out bulb is located, turn it counter-clockwise and replace it with a bulb of the same type. 13B) - when performing this operation hold the opaque glass carefully. 10) A: Light switch on/off B: Motor switch on/off (1st rate level) nd C: 2 rate level switch rd D: 3 rate level switch th E: 4 rate level switch F: 10-minute timer. [. . . ]