User manual FAGOR 3CFT-DEEP90 X

[. . . ] Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. The hood is equipped with a top air outlet B for discharge of fumes to the outside (exhaust pipe and pipe fixing clamps not provided). [. . . ] Once the timer has begun counting down, it may be cancelled by pressing the TIMER button. "-" Decrease motor speed / OFF button The OFF status can be achieved by pressing the "-" button and decreasing the motor speed until it stops. "+" Increase motor speed / ON button The ON status can be achieved by pressing the "+" button; the motor will start at the lowest speed level. The speed sequence is 1-2-3-4, therefore every time the "+" button is pressed the motor moves on to the next speed level. If the motor is at the 4th speed level and the "+" button is pressed, you will hear a beep. The standard period of time is 5', at the end of which the hood reverts to speed level 2. To deactivate the function before the set time has elapsed, simply press the "-" button. SPECIAL FUNCTIONS Programming the Clock The clock may be set at any time, apart from when the timer function is active. The clock may be displayed in a 12-hour format, indicating a time between 1:00 and 12:59. The clock may be reset by pressing and holding the "Timer" button for 5 seconds, then pressing the "-" and "+" buttons to adjust the time. The user may increase/decrease the time in steps of 1 minute; however, if the "-" or "+" button is pressed for 1 second, the time is decreased/increased in steps of 5 minutes. In this case, the control panel rounds the time off to the nearest 5 minutes. The user can end the clock resetting stage by pressing the "Timer" button. If none of the buttons are pressed for 1 minute, the control panel accepts the set value and adds on 1 minute, then begins to operate normally. Grease filter warning After 40 hours of operation, "Grease Filter" appears on the display. To reset the grease filter warning, the user should press and hold the "+" button for 5 seconds. After this action, the "Grease Filter" text will disappear, a "beep" will be emitted to indicate the process is compete and the display will return to showing its normal operating functions. the grease filter counter will reset after this procedure is complete. Charcoal filter warning After 160 hours of operation, "Charcoal Filter" appears on the display. To reset the charcoal filter warning, the user should press and hold the "-" button for 5 seconds. After this action, the "Charcoal Filter" text will disappear, a "beep" will be emitted to indicate the process is compete and the display will return to showing its normal operating functions. the charcoal filter counter will reset after this procedure is complete. [. . . ] Do not connect the appliance to the mains until the installation is fully complete. Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under On the product, or on the documents The symbol accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ]