User manual FAGOR 2F2607

[. . . ] On built-in washing machines, the mains plug must be accessible after installation. 5 PANELLING It is easy to change the coating of the washing machine panels to match your kitchen furniture. a Loosen the screws of the hinges and dismantle the door of the washing machine. Extract the panel that was supplied with the washing machine. a b c c If the new panel is 3 mm. thick, place it over the panel originally supplied with the washing machine. In order to assemble the door with the new decorative panel, repeat the steps given in points a, b, c. English It is also possible to adjust the height of the decorative door in order to align it with the rest of the kitchen furniture and fittings. [. . . ] The detergent drawer of your washing machine has three compartments. Pre-wash Compartment. Liquid Additive Compartment (softeners, . . . ) IMPORTANT The liquid level should never exceed the MAX reference mark on the side of the drawer. 59 You may also use liquid detergents with this washing machine, using the optional drawer that may be acquired through the Technical Support Network. Remember that the dose of detergent to be used always depends on G The amount of laundry to be washed. G The hardness of the water (You can request information on the water hardness from the competent local entities). ECOLOGICAL NOTE Remember that there are concentrated detergents that are more careful with nature and the environment. Using more detergent than is needed does not improve the wash results and as well as being a waste of money, it has a negative effect on the preservation of the environment. Therefore, please follow the instructions supplied by the manufacturer of the detergent. English 3 a b c d SELECTING THE WASH PROGRAMME There are four types of programme: Normal Programmes Delicate Programmes Wool Programmes Auxiliary Programmes To select the wash programme, please follow these steps: 1. Turn ON the machine (by pressing the programme selector, which pops out). Select the wash programme by turning the Programme Selector Dial. 1. 2. If your washing machine is a fully integrated model, instead of pressing the programme selector control, you have to press the button in the middle of the control panel, shown in the photo. display When you do this, the spin speed light corresponding to the selected programme will light up. If your washing machine has a display, when you select the programme, it will light up for a few seconds, showing P + programme number (P01. Then it will show the approximate duration of the programme in minutes. The time that appears on the display changes according to the progress of the programme ECOLOGICAL NOTE We recommend that you should choose the programme that is most suited to your wash, in order to avoid the pre-wash whenever possible. On washing machines with a display, the screen will flash showing the time left before the programme starts. When the delay time has elapsed, it will stop flashing and show the duration of the IMPORTANT If you need to add or remove a garment, select pause and ensure that the water level is not over the door and that the inside temperature is not high. f you press the ON button, the wash will recommence at the same stage of the cycle where it stopped. programme selected. On washing machines with indicator lights, when the On/Off button is pressed, the time indicator will flash, successively showing the time remaining for the wash programme to begin. 6 STAGES IN WASH PROGRAMME ton during the wash has no effect on the washing IMPORTANT If you use the selector to change programmes while the machine is working, it will enter the PAUSE mode. If you press the On/ Off button during the wash, the washing machine will enter the PAUSE mode and this button's light will turn off. Pre-wash Wash Rinse End The active phases at each point of the programme shall appear as the programme progresses. Any option button may be selected as long as the phase in the programme in which it takes effect has not ended and as long as the programme allows this option. Pressing the delay but- 67 7 POWER CUTS stopped (it has an hour memory). The same occurs if your press the OFF button and then the ON button. In the event of a power cut, when the supply returns, the washing machine will continue to function normally, starting off where it had 8 TIPS G In order to reduce the noise produced during the spin cycle, level the washing machine using the adjustable feet. this improves the distribution of the clothes in the drum during the spin cycle. G All models have a spin safety system that does not allow the machine to perform the spin cycle if the distribution of the laundry in the drum is very concentrated. If at any moment ECOLOGICAL NOTE With the aim of preserving the environment, your washing machine is equipped with a system that is able to adapt to the different conditions of use (laundry load and type of material) , thereby ensuring an optimum level of water and energy. [. . . ] This fault occurs because the laundry is not evenly distributed in the drum, which can cause too much vibration. . Is it better to put the detergent in the drawer or directly in the drum? The use of "detergent tablets" that go directly into the drum is increasingly common. However, other powder and liquid detergents contain aggressive components that may damage clothes if applied directly to the garments. In this case, we recommend you use the drawer 73 Why can't I see water in the drum? This could be because the washing machine has a system that allows it to adapt to the laundry load and the type of material, adjusting the water level and the energy used with a view to preserving the environment. [. . . ]